User manual MAKITA DCS5121 SPARE PARTS LIST

[. . . ] For the components listed under PARTS COVERED, the service dealer authorized by MAKITA will, at no cost to you, make the necessary diagnosis, repair, or replacement necessary to ensure that the engine complies with applicable U. EMISSION COMPONENT DEFECT WARRANTY PERIOD The warranty period for this engine begins on the date of sale to the initial purchaser and continues for a period of 2 years. PARTS COVERED Listed below are the parts covered by the Emission Components Defect Warranty. Some of the parts listed below may require scheduled maintenance and are warranted up to the first scheduled replacement point for that part. [. . . ] When the tree starts to fall, shut off the engine, withdraw the bar and walk away on the pre-planned escape path. Be extremely careful with partially fallen trees which are poorly supported. When the tree hangs or for some other reason does not fall completely, set the saw aside and pull the tree down with a cable winch, block and tackle or tractor. Timber having a diameter more than twice the length of the guide bar reauires the use of the plunge-cut method before making the felling cut. Begin the plunge cut by applying the lower portion of the guide bar nose to the tree at an angle (fig. Cut until depth of the kerf is about the same as the width of the guide bar (fig. Next, align the saw in the direction With the saw at full throttle, insert the guide bar in the trunk (fig. Felling a tree that has a diameter greater than the length of the guide bar requires use of either the sectioning or plunge-cut method. These methods are extremely dangerous because they involve the use of the nose of the guide bar and can result in kickback. 24) make the first cut with the guide bar fanning in toward the hinge. Then, using the bumper spike as a pivot, reposition the saw for the next cut. Turn the chain adjusting screw (C/6) to the left (counterclockwise) until the pin (C/7) is at the left stop. Using your right hand, guide the chain into the top guide groove on the guide bar (E/8). NOTE: The cutting edges along the top of the chain must point in the direction of the arrow!F Lead the chain (F/10) around the sprocket nose (F/12) of the guide bar. NOTE: The chain should be easy to pull in the direction of the arrow. Turn the chain tightener (G/6) to the right (clockwise) until the chain engages the guide groove of the bottom side of the bar (see circle). I Tightening the saw chain - Slightly lift the end of the guide bar and turn the chain adjusting screw (I/6) to the right (clockwise) until the chain rests against the bottom side of the guide bar. - While still holding up the tip of the guide bar, tighten the retaining nuts (H/3) with the universal wrench. J The tension of the chain is correct if the chain rests against the bottom side of the guide bar and can still be easily turned by hand. NOTE: Check the chain tension frequently - chains tend to get longer during use!If this is not done, there is a risk of the chain jumping off the bar. [. . . ] Make a habit of it, it does not require much time and your saw will always function properly. Possibly hidden faults can be detected in this manner before causing expensive and annoying interruptions of your work. In case you should detect a fault in the safety equipment when performing daily servicing, the saw must not be used before elimination of the fault. The user of the chain saw must not perform maintenance work which is not described in the instruction manual. [. . . ]