User manual MAKITA BUM168

[. . . ] Turn Shear blade Crank Basic alignment line on the tool housing Pins Recessed part of crank Apply grease Base plate Hole in the base plate of shear blades Oval holes that are overlapped Groove in the undercover Brush Machine oil Hedge shear blade Hedge shear blade cover 33. Blade cover to be always installed before installing the chip receiver 46. 6 kg DC18RC, DC18SD 200 mm • Due to our continuing program of research and development, the specifications herein are subject to change without notice. € Specifications and battery cartridge may differ from country to country. [. . . ] Installing or removing grass shear blades CAUTION: • Always be sure that the tool is switched off and the battery cartridge is removed before installing or removing shear blades. Failure to switch off and remove the battery cartridge from the tool may result in serious injury from accidental start-up. € When replacing the shear blade, always wear gloves without removing blade cover so that hands and face does not directly contact the blade. € For specific way of removing and installing shear blades refer to the reverse of a package for accessory shear blades. CAUTION: • Before placing the tool upside down, be sure to remove the base frame. 11) To remove the shear blade, press the locking lever and with the locking lever pressed turn the undercover counterclockwise until the symbol on the undercover is aligned with the symbol ' on the locking lever. 12) Take out the undercover, shear blade and crank in order from the tool. 13) To install the grass shear blade, prepare the crank, undercover and new grass shear blade. 14) Take out the blade cover from the old shear blades and fit it onto the new ones for easy handling during the replacement of blades. 15) Adjust the three pin position so that these pins are lined up at right angle in relation to the basic alignment line on the tool housing. 16) 13 ASSEMBLY CAUTION: • Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool. Installing or removing blade cover CAUTION: • Be careful not to contact the shear blade when installing or removing the blade cover. 6 & 7) Slide the blade cover from the tool’s side until the shear blade completely hides itself and then push in it lightly towards the tool from the front. To remove the blade cover, take the above installation procedure in reverse. Installing or removing base frame CAUTION: • Before installing or removing base frame, be sure to install the blade cover. € When installing or removing base frame, take care that your fingers are not be pinched between the tool and base frame. 8) To remove the base frame, upset the tool and take it out of the groove grabbing its bottom. 9) To install the base frame, fit the protrusion of base frame near the change lever into the hole for the sheared grass height setting. With the base frame so fitted, pull the lower Fit the crank with its recessed part facing upwards onto the pins. At this time, apply a small amount of grease to the periphery of the crank using grease that the shear blades as optional accessory are provided with or that remains inside gear housing. 17) Overlap the oval hole in the upper blade with that in the lower one. Move the shear blades so that the hole in the base plate of shear blades are positioned in the center of these overlapped oval holes. [. . . ] ENG901-1 • The declared vibration emission value has been measured in accordance with the standard test method and may be used for comparing one tool with another. € The declared vibration emission value may also be used in a preliminary assessment of exposure. WARNING: • The vibration emission during actual use of the power tool can differ from the declared emission value depending on the ways in which the tool is used. € Be sure to identify safety measures to protect the operator that are based on an estimation of exposure in the actual conditions of use (taking account of all parts of the operating cycle such as the times when the tool is switched off and when it is running idle in addition to the trigger time). [. . . ]