User manual MAKITA BTD134

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual MAKITA BTD134. We hope that this MAKITA BTD134 user guide will be useful to you.


MAKITA BTD134 : Download the complete user guide (1237 Ko)

Manual abstract: user guide MAKITA BTD134

Detailed instructions for use are in the User's Guide.

[. . . ] If operating time has become excessively shorter, stop operating immediately. It may result in a risk of overheating, possible burns and even an explosion. If electrolyte gets into your eyes, rinse them out with clear water and seek medical attention right away. Hold power tool by insulated gripping surfaces, when performing an operation where the fastener may contact hidden wiring. [. . . ] €¢ To install the battery cartridge, align the tongue on the battery cartridge with the groove in the housing and slip it into place. Always insert it all the way until it locks in place with a little click. If not, it may accidentally fall out of the tool, causing injury to you or someone around you. If the cartridge does not slide in easily, it is not being inserted correctly. When the reversing switch lever is in the neutral position, the switch trigger cannot be pulled. CAUTION: • Always check the direction of rotation before operation. €¢ Use the reversing switch only after the tool comes to a complete stop. Changing the direction of rotation before the tool stops may damage the tool. €¢ When not operating the tool, always set the reversing switch lever to the neutral position. 6) Stop the tool and with the tool stopped press the button on the switch panel and the remaining battery capacity will be signaled on the panel. The status displayed on the switch panel and the remaining battery capacity is shown in the following table. LED indicator status Remaining battery capacity About 50% or more About 20% - 50% About less than 20% NOTE: • Before checking the remaining battery capacity, be sure to stop the tool. To install the hook, insert it into a groove in the tool housing on either side and then secure it with a screw. OPERATION The proper fastening torque may differ depending upon the kind or size of the screw/bolt, the material of the workpiece to be fastened, etc. The relation between fastening torque and fastening time is shown in the figures. 11, 12 & 13) Hold the tool firmly and place the point of the driver bit in the screw head. Apply forward pressure to the tool to the extent that the bit will not slip off the screw and turn the tool on to start operation. NOTE: • Use the proper bit for the head of the screw/bolt that you wish to use. [. . . ] 14) Use a screwdriver to remove two screws then remove the rear cover. 15) Raise the arm part of the spring and then place it in the recessed part of the housing with a slotted bit screwdriver of slender shaft or the like. Take out the worn carbon brushes, insert the new ones and replace the carbon brush cap in reverse. 18) Make sure that the carbon brush caps fit into the holes in brush holders securely. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE MAKITA BTD134




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual MAKITA BTD134 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.