User manual MAKITA BTD132

[. . . ] Stay alert, watch what you are doing and use common sense when operating a power tool. Do not use a power tool while you are tired or under the influence of drugs, alcohol or medication. A moment of inattention while operating power tools may result in serious personal injury. Safety equipment such as dust mask, non-skid safety shoes, hard hat, or hearing protection used for appropriate conditions will reduce personal injuries. [. . . ] To remove the battery cartridge, withdraw it from the tool while sliding the button on the front of the cartridge. To insert the battery cartridge, align the tongue on the battery cartridge with the groove in the housing and slip it into place. Always insert it all the way until it locks in place with a little click. If you can see the red part on the upper side of the button, it is not locked completely. If not, it may accidentally fall out of the tool, causing injury to you or someone around you. If the cartridge does not slide in easily, it is not being inserted correctly. With the light button in the ON status, pull the switch trigger to turn on the light. To turn off, release it and the light goes out approximately 10 seconds after releasing. With the light button in the OFF status, even if the trigger is pulled, the lamp will not light on. nOTE: · To make sure the status of light, pull the trigger. When the lamp lights up by pulling the switch trigger, the light switch is in the ON status. When the lamp does not come on, the light switch is in the OFF status. ⷠDuring the operation of switch trigger, the light status cannot be changed. ⷠFor approximately 10 seconds after releasing the switch trigger, the light status can be switched. CAUTION: Before inserting the battery cartridge into the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released. If the tool consistently fails to quickly stop after switch trigger release, have tool serviced at a Makita service center. CAUTION: Do not look in the light or see the source of light directly. Depress the reversing switch lever from the A side for clockwise rotation or from the B side for counterclockwise rotation. When the reversing switch lever is in the neutral position, the switch trigger cannot be pulled. Use the reversing switch only after the tool comes to a complete stop. Changing the direction of rotation before the tool stops may damage the tool. When not operating the tool, always set the reversing switch lever to the neutral position. [. . . ] If inspection shows the trouble is caused by defective workmanship or material, Makita will repair (or at our option, replace) without charge. This Warranty does not apply where: repairs have been made or attempted by others: repairs are required because of normal wear and tear: the tool has been abused, misused or improperly maintained: alterations have been made to the tool. This Warranty gives you specific legal rights, and you may also have other rights which vary from state to state. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. [. . . ]