User manual MAKITA BO5021K

[. . . ] Power supply The tool should be connected only to a power supply of the same voltage as indicated on the nameplate, and can only be operated on single-phase AC supply. They are double-insulated in accordance with European Standard and can, therefore, also be used from sockets without earth wire. Safety hints For your own safety, please refer to the enclosed Safety instructions. [. . . ] Installing paper dust bag To install the paper dust bag, place the paper dust bag on the paper dust bag holder with its front side upward. Insert the front fixing cardboard of the paper dust bag into the groove of the paper dust bag holder. 6) Then press the upper part of the front fixing cardboard in arrow direction to hook it onto the claws. 7) Insert the notch of the paper dust bag into the guide of the paper dust bag holder. Keep the pad flush with the workpiece and apply slight pressure on the tool. cAUTION: · Never run the tool without the abrasive disc. ON-LOAD The sanding pad rotates clockwise during the loaded operation, but it may rotate counterclockwise during the no-load operation. Install the front grip on the tool so that its protrusions fit into the matching notches in the front of the tool. Secure the front grip using a screwdriver to tighten the screw through the hole in the front grip. Use only a Makita genuine sponge pad, felt pad or wool pad (optional accessories). ⷠAlways operate the tool at low speed to prevent work surfaces from heating abnormally. nOTE: · First, wax a not conspicuous portion of the work surface to make sure that the tool will not scratch the surface or result in uneven waxing. Run the tool at low speed and apply the wool pad gently to the work surface. CAUTION: Before plugging in the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released. [. . . ] CAUTION: These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. The accessories or attachments should be used only in the proper and intended manner. [. . . ]