User manual MAKITA BJS160

[. . . ] Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Before using battery cartridge, read all instructions and cautionary markings on (1) battery charger, (2) battery, and (3) product using battery. It may result in a risk of overheating, possible burns and even an explosion. If electrolyte gets into your eyes, rinse them out with clear water and seek medical attention right away. [. . . ] For continuous operation, press the front of the switch lever to lock it. - Battery cartridge replacing signal - When the battery power is almost used up during operation, the red lamp lights up and the tool stops immediately. Replace the battery with fully charged one when the red lamp lights up. - Accidental re-start preventive function - Even if the battery cartridge is inserted on the tool with the slide switch in the "I (ON)" position, the tool does not start. At this time, the lamp flickers slowly and this shows that the accidental re-start preventive function is at work. - To start the tool, first slide the slide switch toward the "O (OFF)" position and then slide it toward the "I (ON)" position. Always stop tool operation and charge the battery cartridge when you notice less tool power. Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool. Always be sure that the tool is switched off and the battery cartridge is removed before adjusting or checking function on the tool. For BJS160 and BJS161 only Adjust the clearance between the side blade and the center blade according to the thickness of the workpiece. There may be a slight difference between clearance of both sides of the center blade. Always switch off the tool before insertion or removal of the battery cartridge. â· To remove the battery cartridge, withdraw it from the tool while sliding the button on the front of the cartridge. The following reference tables indicate the approximate service life of the blades. When the blades become dull, ask Makita Authorized Service Centers to replace the blades. Before operation, lubricate the contact point of the center blade and the pin. To keep good cutting performance, also use a cutting lubricant from time to time during operation. Turn the tool on and set front ends of the side blades on the workpiece. Now simply move the tool forward, keeping the side blades flush with the workpiece surface. When cutting a small portion of the workpiece, you may have difficulty completing the end of the cut. [. . . ] For Model BJS161 For European countries only ENG104-1 Noise The typical A-weighted noise level determined according to EN60745: Sound pressure level (LpA): 71 dB (A) Uncertainty (K): 3 dB (A) The noise level under working may exceed 80 dB (A). 5 m/s2 For Model BJS100 For European countries only ENG104-1 Noise The typical A-weighted noise level determined according to EN60745: Sound pressure level (LpA): 71 dB (A) Uncertainty (K): 3 dB (A) The noise level under working may exceed 80 dB (A). 5 m/s2 For Model BJS101 For European countries only ENG104-1 Noise The typical A-weighted noise level determined according to EN60745: Sound pressure level (LpA): 71 dB (A) Uncertainty (K): 3 dB (A) The noise level under working may exceed 80 dB (A). EC Declaration of Conformity ENH101-12 We Makita Corporation as the responsible manufacturer declare that the following Makita machine(s): Designation of Machine: Cordless Metal Shear Model No. [. . . ]