User manual MAKITA BJR182

[. . . ] Do not use a power tool while you are tired or under the influence of drugs, alcohol or medication. A moment of inattention while operating power tools may result in serious personal injury. Safety equipment such as dust mask, non-skid safety shoes, hard hat, or hearing protection used for appropriate conditions will reduce personal injuries. Carrying power tools with your finger on the switch or plugging in power tools that have the switch on invites accidents. [. . . ] Make sure the blade is not contacting the workpiece before the switch is turned on. Always switch off and wait for the blade to come to a complete stop before removing the blade from the workpiece. Do not touch the blade or the workpiece immediately after operation; they may be extremely hot and could burn your skin. Always use the correct dust mask/respirator for the material and application you are working with. If electrolyte gets into your eyes, rinse them out with clear water and seek medical attention right away. Do not short the battery cartridge: (1) Do not touch the terminals with any conductive material. A battery short can cause a large current flow, overheating, possible burns and even a breakdown. Do not store the tool and battery cartridge in locations where the temperature may reach or exceed 50°C (122°F). Do not incinerate the battery cartridge even if it is severely damaged or is completely worn out. WARNING: MISUSE or failure to follow the safety rules stated in this instruction manual may cause serious personal injury. Always stop tool operation and charge the battery cartridge when you notice less tool power. CAUTION: Always be sure that the tool is switched off and the battery cartridge is removed before adjusting or checking function on the tool. Before using battery cartridge, read all instructions and cautionary markings on (1) battery charger, (2) battery, and (3) product using battery. Always switch off the tool before insertion or removal of the battery cartridge. To remove the battery cartridge, withdraw it from the tool while sliding the button on the front of the cartridge. To insert the battery cartridge, align the tongue on the battery cartridge with the groove in the housing and slip it into place. Always insert it all the way until it locks in place with a little click. If you can see the red part on the upper side of the button, it is not locked completely. If not, it may accidentally fall out of the tool, causing injury to you or someone around you. If the cartridge does not slide in easily, it is not being inserted correctly. CAUTION: Before inserting the battery cartridge into the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released. ⷠWhen not operating the tool, depress the lock-off button from A side to lock the switch trigger in the OFF position. [. . . ] ⷠBe sure to always wear suitable eye protection which conforms with current national standards. ⷠAlways use a suitable coolant (cutting oil) when cutting metal. Bring the blade into light contact with · Insert the saw blade into the blade clamp as far as it will go. Make sure that the saw blade cannot be extracted even though you try to pull it out. [. . . ]