User manual MAKITA BHR202RFE

[. . . ] Unmodified plugs and matching outlets will reduce risk of electric shock. Avoid body contact with earthed or grounded surfaces such as pipes, radiators, ranges and refrigerators. There is an increased risk of electric shock if your body is earthed or grounded. Never use the cord for carrying, pulling or unplugging the power tool. [. . . ] (2) Avoid storing battery cartridge in a container with other metal objects such as nails, coins, etc. A battery short can cause a large current flow, overheating, possible burns and even a breakdown. Do not store the tool and battery cartridge in locations where the temperature may reach or exceed 50 C (122 F). Do not incinerate the battery cartridge even if it is severely damaged or is completely worn out. Be careful not to drop or strike battery. · · · · Always switch off the tool before insertion or removal of the battery cartridge. To remove the battery cartridge, withdraw it from the tool while sliding the button on the front of the cartridge. To insert the battery cartridge, align the tongue on the battery cartridge with the groove in the housing and slip it into place. Always insert it all the way until it locks in place with a little click. If you can see the red part on the upper side of the button, it is not locked completely. If not, it may accidentally fall out of the tool, causing injury to you or someone around you. Depress the reversing switch lever from the A side for clockwise rotation or from the B side for counterclockwise rotation. When the reversing switch lever is in the neutral position, the switch trigger cannot be pulled. Use the reversing switch only after the tool comes to a complete stop. Changing the direction of rotation before the tool stops may damage the tool. When not operating the tool, always set the reversing switch lever to the neutral position. 1 007577 For chipping, scaling or demolition operations, depress the lock button and rotate the action mode changing symbol. CAUTION: Do not rotate the action mode changing knob when the tool is running. To avoid rapid wear on the mode change mechanism, be sure that the action mode changing knob is always positively located in one of the three action mode positions. · · · · · Selecting the action mode Rotation with hammering 2 1 Torque limiter 1. Action mode changing knob The torque limiter will actuate when a certain torque level is reached. CAUTION: As soon as the torque limiter actuates, switch off the tool immediately. This will cause the torque limiter to actuate too frequently. · 3 007575 · For drilling in concrete, masonry, etc. , depress the lock button and rotate the action mode changing knob to the symbol. Chuck cover 1 2 CAUTION: Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool. Side grip (auxiliary handle) 1 5 6 2 4 3 1. Tighten 007342 008830 If the bit cannot be pushed in, remove the bit. [. . . ] Set the action mode changing knob so that the pointer points to the symbol. CAUTION: Never use "rotation with hammering" when the drill chuck assembly is installed on the tool. In fact, this excessive pressure will only serve to damage the tip of your bit, decrease the tool performance and shorten the service life of the 9 1. Holder cap cover 2 · 008834 · Use a screwdriver to remove the brush holder caps. [. . . ]