User manual MAKITA AN911H

[. . . ] (7) Do not load the tool with fasteners when any one of the operating controls is activated. (8) Do not operate the tool with any power source other than that specified in the tool operating/safety instructions. Do not use the tool near volatile, flammable materials such as gasoline, thinner, paint, gas, adhesives, etc. The area should be sufficiently illuminated to assure safe operations. [. . . ] The graph shows the relation between nailing frequency, applicable pressure and compressor air output. Thus, for example, if nailing takes place at a rate of approximately 50 times per minute at a compression of 1. Pressure regulators must be used to limit air pressure to the rated pressure of the tool where air supply pressure exceeds the tool's rated pressure. Failure to do so may result in serious injury to tool operator or persons in the vicinity. Adjust the oiler so that one drop of oil will be provided for every 30 nails. When an air set is not used, oil the tool with pneumatic tool oil by placing 2 (two) or 3 (three) drops into the air fitting. For proper lubrication, the tool must be fired a couple of times after pneumatic tool oil is introduced. When changing the installation position, remove the screw with a screwdriver. Install the hook on another side for installation and then secure it with the screw. Install the hook on another side for installation and then secure it with the screw. Use the nose adapter CAUTION: Always disconnect the hose before installing or removing the nose adapter. If you like to protect the surface of workpiece, attach the nose adapter of contact element. When nailing workpieces with easily-marred surfaces, use the nose adapter. To attach the nose adapter to the contact element, press it onto the contact element until the protrusion in three places inside the nose adapter fit in three holes in the contact element. CAUTION: Always disconnect the hose when hanging the tool using the hook. CAUTION: Make sure that the coil support plate is set to the correct step for used nails. Lift and turn the coil support plate so that the arrow with nail size indicated on the coil support plate will point to the corresponding graduation increment marked on the magazine. If the tool is operated with the coil support plate set to the wrong step, poor nail feed or malfunction of the tool may result. Place the first nail in the feeder and the second nail in the feed claw. Close the magazine cap slowly until it lock after checking to see that the nail coil is set properly in the magazine. Pull the trigger first and then place the contact element against the workpiece. (1) method is for intermittent nailing, when you wish to drive a nail carefully and very accurately. [. . . ] Storage When not in use, the nailer should be stored in a warm and dry place. CAUTION: Always disconnect the air hose and remove the nails from the magazine before cleaning a jam. when the nailer becomes jammed , do as follows: Open the magazine cap and remove the nail coil. Insert a small rod or the like into the ejection port and tap it with After operation, always drain the compressor tank and the air filter. [. . . ]