User manual MAKITA AN250HC

[. . . ] (7) Do not load the tool with fasteners when any one of the operating controls is activated. (8) Do not operate the tool with any power source other than that specified in the tool operating/safety instructions. Do not use the tool near volatile, flammable materials such as gasoline, thinner, paint, gas, adhesives, etc. The area should be sufficiently illuminated to assure safe operations. [. . . ] MISUSE or failure to follow the safety rules stated in this instruction manual may cause serious personal injury. Operators and others in work area must wear safety glasses with side shields. Keep fingers away from trigger when not driving fasteners to avoid accidental firing. Use an air hose as large and as short as possible to assure continuous, efficient pin-driving operation. CAUTION: Low air output of the compressor, or a long or smaller diameter air hose in relation to the pin-driving frequency may cause a decrease in the driving capability of the tool. Adjust the oiler so that one drop of oil will be provided for every 30 pins. The graph shows the relation between pin-driving frequency, applicable pressure and compressor air output. Thus, for example, if pin driving takes place at a rate of approximately 15 times per minute at a compression of 250 PSIG (1. Pressure regulators must be used to limit air pressure to the rated pressure of the tool where air supply pressure exceeds the tool's rated pressure. Failure to do so may result in serious injury to tool operator or persons in the vicinity. When an air set is not used, oil the tool with pneumatic tool oil by placing two or three drops into the air fitting. For proper lubrication, the tool must be fired a couple of times after pneumatic tool oil is introduced. When changing the installation position, remove the screw with a screwdriver. Install the hook on another side for installation and then secure it with the screw. Install the hook on another side for installation and then secure it with the screw. Use the nose adapter CAUTION: Always disconnect the hose before installing or removing the nose adapter. If you like to avoid shifting of driving points by slippage on workpiece, attach the nose adapter of contact element. Usually use one of two nose adapter A (transparent) , one factory-installed on the contact element and the other stored below the grip. When working on narrow partition tracks, use nose one of two nose adapter B (black) which are provided with in the tool carton box. To attach the nose adapter to the contact element, press it onto the contact element as far as it will go. This nailer is provided with the mechanism for locking trigger to avoid personal injuries and property damage caused by improper operation during other than pin-driving operation. CAUTION: Always disconnect the hose when hanging the tool using the hook. [. . . ] Hoses must also be directed away from sharp edges and areas which may lead to damage or abrasion to the hose. To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjustment should be performed by Makita Authorized or Factory Service Centers, always using Makita replacement parts. CAUTION: These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. [. . . ]