User manual MAKITA 9227CB

[. . . ] Safety hints For your own safety, please refer to the enclosed safety instructions. Other personal protective equipment such as dust mask, gloves, helmet and apron should be worn when necessary. Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. [. . . ] Important: Always be sure that the tool is switched off and unplugged before installing the loop handle. Hold the tool's switch handle and the loop handle firmly with both hands during operation. Install the loop handle so that its protrusion will fit into the matching hole in the gear housing. The loop handle can be installed in two different directions as shown in Fig. The tool speed can be infinitely adjusted between 600 rpm and 3, 000 rpm (rpm at the time when the switch trigger is fully pulled) by turning the speed adjusting dial to a given number setting from 1 to 6. Higher speed is obtained when the dial is turned in the direction of number 6; lower speed is obtained when it is turned in the direction of number 1. Refer to the table below for the relationship between the number settings on the dial and the approximate tool speed. Press the shaft lock to prevent spindle rotation when installing or removing accessories such as wool pads. Important: Always be sure that the tool is switched off and unplugged before installing or removing the wool pad. To install the wool pad, first remove all dirt or foreign matter from the backing pad. Using the sleeve 18 as a positioning guide, install the wool pad on the backing pad with the sleeve 18 inserted through the center hole of the wool pad. If the tool is operated continuously at low speeds for a long time, the motor will get overloaded and heated up. The speed adjusting dial can be turned only as far as 6 and back to 1. Do not force it past 6 or 1, or the speed adjusting function may no longer work. CAUTION: Always wear safety glasses or a face shield during operation. Pull the trigger and turn the speed adjusting dial until you obtain the appropriate speed for your work. When polishing, keep the wool pad at an angle of about 15° to the workpiece surface. CAUTION: Before plugging in the tool, always check to see that the switch trigger actuates properly and returns to the ``OFF'' position when released. [. . . ] Varvtalsinställningsratten kan endast vridas till siffran 6 och sedan tillbaka till 1. CAUTION: These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. [. . . ]