User manual MAKITA 6723DW

[. . . ] Use battery operated tool only with specifically designated battery pack. Stay alert, watch what you are doing, and use common sense when operating a power tool. Do not use tool while tired or under the influence of drugs, alcohol, or medication. A moment of inattention while operating power tools may result in serious personal injury. [. . . ] DO NOT let comfort or familiarity with product (gained from repeated use) replace strict adherence to cordless screwdriver safety rules. If you use this tool unsafely or incorrectly, you can suffer serious personal injury. Hold tool by insulated gripping surfaces when performing an operation where the cutting tool may contact hidden wiring. Contact with a "live" wire will also make exposed Be aware that this tool is always in an operating condition, because it does not have to be plugged into an electrical outlet. WARNING: MISUSE or failure to follow the safety rules stated in this instruction manual may cause serious personal injury. WARNING: Read these safety instructions carefully before connecting the charger to the mains supply. Do not allow the cordless screwdriver to be exposed to rain or moisture. This symbol indicates that this charger is a Class II appliance and does not require an Earth connection. New batteries, or a battery that has been stored uncharged for some time, may not initially accept a full charge. The battery should always be charged at ambient air temperatures of between 4° and 40°C. After the initial 5 hour charge, the screwdriver will be ready for use. Switch off and remove the charging adaptor from the mains supply and remove the charging plug from the screwdriver. This is normal and will continue until the battery is fully charged and the charger has been disconnected from the mains supply. Do not press the On/Off switch when removing, or installing a screwdriver bit. To insert a screwdriver bit, push it firmly into the screwdriver bit holder. To remove a screwdriver bit, pull it firmly out of the screwdriver bit holder. If required the magnetic bit holder supplied with the screwdriver, can be inserted into the screwdriver bit holder and the screwdriver bit can then be inserted into the magnetic bit holder. This cordless screwdriver is supplied with an 80 piece accessory pack. NOTE: Replacement screwdriver bits can be obtained from most tool or DIY stores. Before operating the On/Off switch, make sure that you have read all of the safety instructions on pages 4, 5 and 6. Using the LED light Press The screwdriver is equipped with an LED light to assist when operating the screwdriver in dark recesses or other poorly lit areas. To switch the LED light On, press the LED light On/Off switch as shown in figure 7. [. . . ] A) Take the battery to your nearest Makita Factory Service Center or b) Take the battery to your nearest Makita Authorized Service Center or Distributor that has been designated as a Makita battery recycling location. All tools, accessories and packaging should be sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment. When the battery inside the screwdriver is no longer required, it must be disposed of in an environmentally protective way. Take it to your tool dealer or a local recycling centre to be disposed of properly. [. . . ]