User manual MAKITA 6722DW

[. . . ] Do not wear loose clothing or jewellery, they can be caught in moving parts. Use safety glasses and if the cutting operation is dusty, a face or dust mask. If devices are provided for the connection of dust extraction and collection ensure these are connected and properly used. Never carry the tool by the cord or yank it to disconnect from the socket. [. . . ] Contact with a "live" wire will also make exposed metal parts of the tool "live" and shock the operator. WARNING: Read these safety instructions carefully before connecting the charger to the mains supply. Do not allow the cordless screwdriver to be exposed to rain or moisture. This symbol indicates that this charger is a Class II appliance and does not require an Earth connection. New batteries, or a battery that has been stored uncharged for some time, may not initially accept a full charge. The battery should always be charged at ambient air temperatures of between 4° and 40°C. After the initial 5 hour charge, the screwdriver will be ready for use. Switch off and remove the charging adaptor from the mains supply and remove the charging plug from the screwdriver. This is normal and will continue until the battery is fully charged and the charger has been disconnected from the mains supply. Do not press the On/Off switch when removing, or installing a screwdriver bit. To insert a screwdriver bit, push it firmly into the screwdriver bit holder. To remove a screwdriver bit, pull it firmly out of the screwdriver bit holder. If required the magnetic bit holder supplied with the screwdriver, can be inserted into the screwdriver bit holder and the screwdriver bit can then be inserted into the magnetic bit holder. This cordless screwdriver is supplied with an 80 piece accessory pack. NOTE: Replacement screwdriver bits can be obtained from most tool or DIY stores. Before operating the On/Off switch, make sure that you have read all of the safety instructions on pages 4, 5 and 6. Using the LED light Press The screwdriver is equipped with an LED light to assist when operating the screwdriver in dark recesses or other poorly lit areas. To switch the LED light On, press the LED light On/Off switch as shown in figure 7. The screwdriver is equipped with a folding handle for either in-line, or pistol grip use. When folded into the pistol grip position it gives assistance when used in areas that may have restricted access. [. . . ] Do not press the On/Off switch when performing cleaning and maintenance procedures. After use, remove the screwdriver bit and tap the side of the screwdriver bit holder to remove any dust, or chippings etc. All tools, accessories and packaging should be sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment. When the battery inside the screwdriver is no longer required, it must be disposed of in an environmentally protective way. [. . . ]