User manual MAKITA 6313D

[. . . ] Do not store the tool and battery cartridge in locations where the temperature may reach or exceed 50°C (122°F). Do not incinerate the battery cartridge even if it is severely damaged or is completely worn out. Always stop tool operation and charge the battery cartridge when you notice less tool power. [. . . ] ⷠTo remove the battery cartridge, withdraw it from the tool while pressing the buttons on both sides of the cartridge. ⷠTo insert the battery cartridge, align the tongue on the battery cartridge with the groove in the housing and slip it into place. Always insert it all the way until it locks in place with a little click. If not, it may accidentally fall out of the tool, causing injury to you or someone around you. ⷠDo not use force when inserting the battery cartridge. If the cartridge does not slide in easily, it is not being inserted correctly. To change the speed, first switch off the tool and then slide the speed change lever to the "II" side for high speed or "I" side for low speed. Be sure that the speed change lever is set to the correct position before operation. cAUTION: · Always set the speed change lever fully to the correct position. If you operate the tool with the speed change lever positioned half-way between the "I" side and "II" side, the tool may be damaged. ⷠDo not use the speed change lever while the tool is running. The fastening torque can be adjusted in 18 steps by turning the adjusting ring so that its graduations are aligned with the pointer on the tool body. The fastening torque is minimum when the number 1 is aligned with the pointer, and maximum when the A marking is aligned with the pointer. The clutch will slip at various torque levels when set at the number 1 to 5. Before actual operation, drive a trial screw into your material or a piece of duplicate material to determine which torque level is required for a particular application. nOTE: · The adjusting ring does not lock when the pointer is positioned only half-way between the graduations. ⷠDo not operate the tool with the adjusting ring set between the number 5 and the A marking. Important: Always be sure that the tool is switched off and the battery cartridge is removed before installing or removing the bit. [. . . ] Drilling in wood When drilling in wood, best results are obtained with wood drills equipped with a guide screw. The guide screw makes drilling easier by pulling the bit into the workpiece. ⷠDrilling in metal To prevent the bit from slipping when starting a hole, make an indentation with a centerpunch and hammer at the point to be drilled. [. . . ]