User manual MAKITA 6015DWE

[. . . ] A battery short can cause a large current flow, overheating, possible burns and even a breakdown. Do not store the machine and battery cartridge in locations where the temperature may reach or exceed 50°C (122°F). Do not incinerate the battery cartridge even if it is severely damaged or is completely worn out. Before using battery charger, read all instructions and cautionary markings on (1) battery charger, (2) battery, and (3) product using battery. [. . . ] When you charge a new battery cartridge or a battery cartridge which has not been used for a long period of time, it may not accept a full charge. You can recharge the battery cartridge fully after discharging it completely and recharging a couple of times. When you charge a battery cartridge from a justoperated machine or a battery cartridge which has been left in a location exposed to direct sunlight or heat for a long time, let it cool off. When you charge a new battery cartridge or a battery cartridge which has not been used for a long period, sometimes the charging light will go out soon. If the charging light goes out within one minute even after repeating this procedure a couple of times, the battery cartridge is dead. If you leave the battery cartridge in the charger to prevent spontaneous discharging after full charge, the charger will switch into its ``trickle charge (maintenance charge)'' mode and keep the battery cartridge fresh and fully charged. Always stop machine operation and charge the battery cartridge when you notice less machine power. Insert the battery cartridge so that the plus and minus terminals on the battery cartridge are on the same sides as their respective markings on the battery charger. When the battery cartridge is inserted, the charging light color will flash in red color and charging will begin. If you leave the battery cartridge in the charger after the charging cycle is complete, the charger will switch into its ``trickle charge (maintenance charge)'' mode. After charging, remove the battery cartridge from the charger and unplug the charger from the power source. Important: Always be sure that the machine is switched off and the battery cartridge is removed before installing or removing the bit. When the reversing switch lever is in the neutral positioin, the tool will not start even if you pull the trigger. cAUTION: · Before inserting the battery cartridge into the machine, always check to see that the switch trigger actuates properly and returns to the ``OFF'' position when released. Use the reversing switch lever only when the machine comes to a complete stop. Changing the direction of rotation before the tool stops may ruin the tool. When not operating the tool, keep the reversing switch lever in the neutral position. Place the point of the driver bit in the screw head and apply pressure to the machine. nOTE: · Make sure that the driver bit is inserted straight in the screw head, or the screw and/or bit may be damaged. When driving wood screws, predrill pilot holes to make driving easier and to prevent splitting of the workpiece. To change the machine speed, turn the speed change knob so that the arrow of the desired speed on the knob is aligned with the reference arrow on the machine body. If the speed change knob does not turn easily, switch on the machine and turn the knob again while the machine is running under no load. [. . . ] To maintain product safety and reliability, repairs, maintenance or adjustment should be carried out by a Makita Authorized Service Center. Damage attributable to normal wear and tear, overload or improper handling will be excluded from the guarantee. In case of complaint, please send the machine, undismantled, with the enclosed GUARANTEE CERTIFICATE, to your dealer or the Makita Service Center. Lämna in batterikassetten till inköpsstället eller till vilken annan butik som helst med försäljning av uppladdningsbara batterier eller apparater. [. . . ]