User manual MAKITA 5090D

[. . . ] Cordless Circular Saw 85 mm (3-3/8") MODEL 5090D INSTRUCTION MANUAL WARNING: For your personal safety, READ and UNDERSTAND before using. Cutting depth No load speed (RPM) Overall length Net weight Battery Charger Input Output Battery Cartridge Voltage Charging time at 90° at 45° 5090D 85 mm (3-3/8") 22 mm (7/8") 18 mm (11/16") 1, 000/min. 7. 2 V - 9. 6 V 9000 9. 6 V 60 min. · Manufacturer reserves the right to change specifications without notice. · Specifications may differ from country to country. GENERAL SAFETY RULES (FOR All BATTERY OPERATED TOOLS) USA003-1 WARNING: Read and understand all instructions. [. . . ] Place the wider portion of the saw base on that part of the workpiece which is solidly supported, not on the section that will fall off when the cut is made. Forcing the saw can cause uneven cuts, loss of accuracy, and possible kickback. 6 clamp it down. That extension cord is properly wired and in good electrical condition; c. That wire size is at least as large as the one specified in the table below. Table 1: RECOMMENDED MINIMUM AWG SIZE FOR EXTENSION CORDS FOR BATTERY CHARGERS Length of Cord (Feet) AWG Size of Cord 25 18 50 18 100 18 150 16 9. Do not operate charger with damaged cord or plug - replace them immediately. Do not operate charger if it has received a sharp blow, been dropped, or otherwise damaged in any way; take it to a qualified serviceman. Do not disassemble charger or battery cartridge; take it to a qualified serviceman when service or repair is required, Incorrect reassembly may result in a risk of electric shock or fire. To reduce risk of electric shock, unplug charger from outlet before attempting any maintenance or cleaning. The battery charger is not intended for use by young children or infirm persons without supervision. Young children should be supervised to ensure that they do not play with the battery charger. 15. If operating time has become excessively shorter, stop operating immediately. It may result in a risk of overheating, possible burns and even an explosion. If electrolyte gets into your eyes, rinse them out with clear water and seek medical attention right away. It may result in loss of your eyesight. 8 ADDITIONAL SAFETY RULES FOR CHARGER & BATTERY CARTRIDGE 1. Do not charge Battery Cartridge when temperature is BELOW 10°C (50°F) or ABOVE 40°C (104°F). Do not attempt to use a step-up transformer, an engine generator or DC power receptacle. Always cover the battery terminals with the battery cover when the battery cartridge is not used. Do not short the battery cartridge: (1) Do not touch the terminals with any conductive material. (2) Avoid storing battery cartridge in a container with other metal objects such as nails, coins, etc. A battery short can cause a large current flow, overheating, possible burns and even a breakdown. Do not store the tool and Battery Cartridge in locations where the temperature may reach or exceed 50°C (122°F). Do not incinerate the Battery Cartridge even if it is severely damaged or is completely worn out. [. . . ] La Mirada, CA 90638-5753 (714) 522-8088 1970 Fulton Avenue Sacramento, CA 95825 (916) 482-5197 7674 Clairemont Mesa Blvd. 105 Van Nuys, CA 91406 (818) 782-2440 GEORGIA 4680 River Green Parkway NW Duluth, GA 30096 (770) 476-8911 NEBRASKA 4129 S. 22 - 24 Las Vegas, NV 89102 (702) 368-4277 TENNESSEE 1120 Elm Hill P. Suile 170 Nashville, TN 372 (615) 248-3321 MARYLAND 7397 Washington Boulevard, Suite 104 Elkridge, MD 21075 (410) 796-4401 NEW JERSEY 251 Herrod Blvd. [. . . ]