User manual MAKITA 4604DW

[. . . ] Always cover the battery terminals with the battery cover when the battery is not used. Do not incinerate the Battery even if it is severely damaged or is completely worn out. Before using battery charger, read all instructions and cautionary markings on (1) battery charger, (2) battery, and (3) product using battery. CAUTION -- To reduce risk of injury, charge only MAKITA type rechargeable batteries. [. . . ] The circuit will not function properly and a malfunction of the charger may result. Wear the waist belt and adjust the lengh of suspenders and waist belt so that the battery will be positioned on your back at waist height. It should be positioned on the side where your hand operates the shears. When wearing it, slip the connection cord through the arm band as shown in Fig. Connect the female plug of the connection cord to the shear connector and turn the screw clockwise to secure the female plug in place. NOTE: If you connect or disconnect the connection cord with the controller switched on, the pilot lamp will blink red and green alternately. When this occurs, the shears will not start even if you pull the switch trigger. Switch off the controller and then switch it on again to start the shears. Both the shears and the controller are equipped with an overload protecting mechanism. If the motor is locked for more than three seconds, this mechanism will actuate to stop the shears. also , the pilot lamp on the controller will start to blink red and green alternately. To resume operation, switch off the controller by pressing the lower (O) side of the switch, then switch it on again. NOTE: Do not operate the shears in such a way that this mechanism actuates frequently. Before connecting the battery to the shears, always check to see that the switch trigger actuates properly and returns to the ``OFF'' position when released. Do not pull the switch trigger without depressing the lock-off lever. The upper shear blade will start to move up as soon as you release the switch trigger and will stop at the highest (wide open) position. In case that the upper shear blade has already opened, it will keep that position with the first trigger operation. 4) To prevent the switch trigger from being accidentally pulled, a lock-off lever is provided. 10) When the switch trigger is pulled and held, the upper shear blade will move down and stop at the closed position. When the switch trigger is released, the upper shear blade will move up and stop at the highest (wide open) position. The pilot lamp will start to blink or remain green when the controller is switched on (the upper (I) side of the switch is pressed). If the pilot lamp blinks red and green alternately, the overload protecting mechanism has been actuated or the connection cord is not firmly connected. [. . . ] In case of complaint, please send the machine, undismantled, with the enclosed GUARANTEE CERTIFICATE, to your dealer or the Makita Service Center. CAUTION: Always be sure that the controller is switched off and the connection cord is disconected from the shears. Push the diamond file in the direction of the arrow to sharpen along the entire blade edge. Maintain the same flat contact with the file consistently along the entire blade edge. [. . . ]