User manual MAKITA 4076DW

[. . . ] This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person 2 16. responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. ENC008-1 SAVE THESE INSTRUCTIONS. This appliance is intended for household use. ENB106-2 IMPORTANT SAFETY INSTRUCTIONS FOR BUILT-IN BATTERY 1. Before using built-in battery, read all instructions and cautionary markings on (1) battery charger, (2) battery, and (3) product using battery. If operating time has become excessively shorter, stop operating immediately. [. . . ] Improper installation may allow dust to enter the motor, resulting in malfunction of the cleaner. · Always switch off the cleaner after each use to prevent damage to the cleaner and to lengthen the service life of the batteries. This cleaner can be operated in "standard" and "strong" suction. To stop the cleaner, slide the switch back to the OFF position. · 008910 ASSEMBLY Dust disposal · · Use only the Makita charger DC7021 to charge this cleaner. Use of other type chargers may cause the battery to burst, resulting in personal injury and damage. Charge the cleaner when it is to be used for the first time or it has been left uncharged for a long time. Connect the charging plug to the charging connector, then plug in the charger to the power receptacle. The light in front of the cleaner switch will come on and charging will begin. When you charge a new cleaner or a cleaner which has been left uncharged for a long time, it may not accept a full charge. You can recharge the cleaner fully after discharging it completely a couple of times. Maximum charging time may be 9 hours depending on room temperature. · CAUTION: Empty the cleaner before it becomes too full, or the suction force weakens. Failure to do so may cause the sponge filter to be clogged or the motor to be damaged. Never throw away the dust stopper because it should be used whenever either the dust bag or the dust pack is used. Lever 1 A · · · 008917 · 4 B 008918 008921 Push the A part of the lever and grab it. Pull the lever in the direction B to open the cover. Remove the dust stopper and empty the cleaner. Dust bag and paper pack Install either dust bag or paper pack before using cleaner. Throw away the entire paper pack without emptying when it has become full. C 009692 Installing dust bag 1 · CAUTION: Do not pull the lever in the direction C with excessive force. Dust stopper 2 008930 Use the dust stopper when installing dust bag. Be careful not to take the upper side for the lower side by mistake because they are different each other. 008919 1 Pull out both the dust stopper and dust bag together at the same time. 1 2 3 1. Dust stopper 008935 1. 008920 Insert the protrusion of the dust bag into the groove in the dust stopper as shown in the figure. 5 1. Hook 3 008923 2 2. There is no distinction between the upper and lower sides of the dust bag. You may insert its protrusion of any side into the lower groove of the dust stopper. 6. Hook the front cover onto the front lip of the cleaner. Then close the front cover. Installing the paper pack 008933 008928 3. Overlap the frame of dust stopper with that of the dust bag. [. . . ] Wall 1 008904 2. 008906 Withdraw the built-in battery halfway. 1 1. Connector Press in the whole edge of the sponge filter against the recessed wall inside the dust bag/dust pack mounting area. CAUTION: After cleaning sponge filter, be sure to install it on the cleaner. An insufficiently dried sponge filter may shorten the service life of the motor. · 008903 3. Disposing cleaner A Ni-Cd battery is built into this cleaner. [. . . ]