User manual MAKITA 4013D

[. . . ] Due to our continuing program of research and development, the specifications herein are subject to change without notice. ⷠNote: Specifications may differ from country to country. Safety hints For your own safety, please refer to the enclosed safety instructions. [. . . ] ⷠDo not use force when inserting the battery cartridge. If the cartridge does not slide in easily, it is not being inserted correctly. Always be sure that the dust bag or paper filter is installed properly in the cleaner before use. Improper installation may allow dust to enter the motor, resulting in malfunction of the cleaner. ⷠAlways switch off the cleaner after each use to prevent damage to the cleaner and to lengthen the service life of the batteries. CAUTION: Empty the cleaner before it becomes too full, or the suction force weakens. 4) Take the dust bag out of the cleaner carefully so that the contents will not spill out. Always install the set plate when using battery cartridges 1200, 1202 or 1202A. 8) CAUTION: Forgetting to install the dust bag, failure to insert the holder of the dust bag all the way into the slots or using a broken or ripped bag, may allow dust to get into the motor. When installing the paper filter, follow the same procedures for the dust bag. ⷠAlways unfold a new paper filter before installing it on the cleaner. CAUTION: Always be sure that the cleaner is switched off and the battery cartridge is removed before carrying out any work on the cleaner. When storing the cleaner, hang it from a nail using the convenient hanger in back. From time to time wipe off the outside (cleaner body) of the cleaner using a cloth dampened in soapy water. [. . . ] The accessories or attachments should be used only in the proper and intended manner. EC-DECLARATION OF CONFORMITY We declare under our sole responsibility that this product is in compliance with the following standards or standardized documents, EN50260, EN55014 in accordance with Council Directives, 89/336/EEC and 98/37/EC. ­ The typical weighted root mean square acceleration value is not more than 2. [. . . ]