User manual MAKITA 3601B

[. . . ] Do not use power tools where there is risk to cause fire or explosion. When not in use, tools should be stored in a dry, high or locked up place, out of reach of children. It will do the job better and safer at the rate for which it was intended. Do not force small tools or attachments to do the job of a heavy duty tool. [. . . ] Watch for vibration or wobbling that could indicate improperly installed bit. ENB033-2 10. Always switch off and wait for the bit to come to a complete stop before removing the tool from workpiece. Do not touch the bit immediately after operation; it may be extremely hot and could burn your skin. Always lead the power supply cord away from the tool towards the rear. Do not smear the tool base carelessly with thinner, gasoline, oil or the like. Draw attention to the need to use cutters of the correct shank diameter and which are suitable for the speed of the tool. 2. 9. SAVE THESE INSTRUCTIONS 4 FUNCTIONAL DESCRIPTION · CAUTION: Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. 005039 Adjusting the depth of cut Place the tool on a flat surface. Place the tool on its side and turn the scale ring counterclockwise (when viewing the tool from the top) until the desired depth of cut is obtained. One full turn of the scale ring is equal to 5 mm change in depth setting. Loosen the knob and move the tool base until it makes contact with the scale ring. CAUTION: Since excessive cutting may cause overload of the motor or difficulty in controlling the tool, the depth of cut should not be more than 15 mm at a pass when cutting grooves. When you wish to cut grooves more than 15 mm deep, make several passes with progressively deeper bit settings. 1 2 1. Knob · 005040 Switch action CAUTION: Before plugging in the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released. For tool with lock button To start the tool, simply pull the switch trigger. For continuous operation, pull the switch trigger and then push in the lock button. To stop the tool from the locked position, pull the switch trigger fully, then release it. Switch trigger 005041 To start the tool, simply pull the switch trigger. Switch trigger 5 ASSEMBLY · CAUTION: Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. 005042 Installing or removing the bit CAUTION: Install the bit securely. · Do not tighten the collet chuck without inserting a bit or install smaller shank bits without using a collet sleeve. Insert the bit all the way into the collet chuck and withdraw it very slightly (approx. When using smaller shank bits, first insert the appropriate collet sleeve into the collet chuck, then install the bit as mentioned above. · OPERATION Set the tool base on the workpiece to be cut without the bit making any contact. [. . . ] Limit mark 005049 Use a screwdriver to remove the rear cover. 1 2 1. Rear cover 10 005050 1 Use a screwdriver to remove the brush holder caps. Take out the worn carbon brushes, insert the new ones and secure the brush holder caps. CAUTION: · Do not turn the tool on without the rear cover installed in place. [. . . ]