User manual MAKITA 2702

[. . . ] Cutting capacities 45° Maximum dado capacity No load speed (RPM) Table size (W x L) Dimensions (L x W x H) Net weight 47 mm (1-3/4") 13 mm (1/2") 4, 600/min. Due to our continuing programme of research and development, the specifications herein are subject to change without notice. Do not wear loose clothing, gloves, neckties, rings, bracelets, or other jewelry which may get caught in moving parts. Everyday eyeglasses only have impact resistant lenses, they are NOT safety glasses. [. . . ] Be sure that the blade is installed so that the teeth are aligned in the cutting (turning) direction. To secure the blade in place, hold the outer flange with the offset wrench, then tighten the hex nut clockwise with the wrench. If your grip should slip, the wrench may come off the hex nut, and your hand could strike the sharp blade edges. If you tighten the hex bolts while grasping the offset wrench further than the striped portion, the hex bolts may be damaged and/or an injury to your hand may result. If the blade and spreader are not aligned properly, a dangerous pinching condition may result during operation. You could suffer serious personal injury while using the tool without a properly aligned spreader. There must be a clearance of about 4 - 5 mm (5/32" -13/ 64") between the spreader and the blade teeth. adjust the spreader accordingly and tighten the hex bolts (A) securely. Attach the table insert on the table, then check to see that the blade guard works smoothly before cutting. CAUTION: Before installing the blade guard, adjust the depth of cut to its maximum elevation. Insert the spreader between the blade guard mounting portion (stay) and the pressure plate. However, if they are not in a straight line, loosen the hex bolts (B) and adjust the blade guard mounting portion (stay) so that the spreader is aligned directly behind the blade. To check to be sure that the rip fence is parallel with the blade, secure the rip fence 2 - 3 mm (5/64" - 1/8" ) from the blade. If the rip fence is not parallel with the blade, proceed as follows: CAUTION: Be sure to adjust the rip fence so that it is parallel with the blade, or a dangerous kickback condition may occur. If the arrow pointer does not point to the 0 graduation, loosen the screw on the scale plate and adjust the scale plate. A wood facing should be used for operations when the blade comes close to the rip fence. Wood facing for the rip fence should be the same size as the rip fence. When cutting long or large workpieces, always provide adequate support behind the table. Before operating the table saw, check to be sure that the antikickback pawls operate properly. Feed the workpiece under the blade guard and along both sides of the blade to simulate cutting. The antikickback pawls should grab the workpiece and prevent it from moving back toward the operator. Always keep the antikickback pawls sharp so they will operate properly. [. . . ] ) For end-type rabbeting, if the workpiece is less than 10-1/2" wide, rest the wood flat on the table against the miter gauge (with wood facing). After rabbeting is completed, immediately re-install the blade guard as before. Mount featherboards to the rip fence and table as shown, so that the leading edges of the featherboards will support the workpiece until the cut is completed, and the workpiece has been pushed completely past the cutter with a push stick. 191543-4) should be used with Makita table saw Model 2702/ Model 2703. [. . . ]