User manual MAGIC CHEF MCWC50DBT

[. . . ] SAVE THESE INSTRUCTIONS: · The cooling system of the appliance is filled with refrigerant and oil , so when the appliance is damaged, handle it with care and dispose of it in compliance with environmental protection safeguards. · The rating plate containing Model No and other technical data specific to this unit, is located either inside the appliance or outside on the rear wall. Disposing of Worn Out Appliances · DANGER OR WARNING: Risk of child entrapment. Important · If you have bought this appliance to replace an old one equipped with a door lock that cannot be opened from the inside (lock, bolt), make sure that the lock is removed, disabled or destroyed before discarding. This will make it impossible for children to accidentally lock themselves inside the appliance and suffocate. · To avoid risk of child entrapment, leave the shelves in place so children can not easily climb inside even when the appliance is in routine use or not in use at home. [. . . ] Note: Make sure the tabs on the rack are well engaged in place before loading any bottles. The top five racks each holds 8 bottles with the necks alternating front to back. The bottom rack consists of two stories, each of which holds 6 bottles with the necks facing the front. Interior Light The appliance has an interior light (E14 socket, max. 15W) for easy interior visibility. WE RESERVE THE RIGHT TO ALTER THE SPECIFICATIONS WITH NO EFFECT ON THE OPERATION OF THE APPLIANCE. 4 Temperature Control and Display Wine Cooler MCWC50DBT Beverage Cooler MCBC580DBT The temperature range of the wine cooler is intended for 43°F to 64°F (+/- 5°F ). The display usually shows the average temperature of the appliance at that moment. PRESET WINE ZONES: Press the [Red] or [White] pads to choose preset storage conditions for Red or White Wine. (The indicator 'RED' or 'WHITE' will light accordingly. ) The programmed Temperature for red or white wine will be displayed for a few seconds. MANUAL TEMPERATURE SETTING: The temperature of the wine cooler can be set anywhere between 43°F to 64°F by the temperature up and temperature down pads as follows: (1) Press the [SET] pad until you hear a "beep" sound (approximately fifteen seconds). (2) Press the pads to increase or decrease the desired temperature in increments of one degree. (3) Press the [SET] pad to confirm your choice - if confirmation is not made within ten seconds the unit will go back to the previous setting. NOTE: The temperature display can be changed between Celsius and Fahrenheit by pressing and holding the pad for approximately 10 seconds. . The temperature range of the beverage cooler is intended for 41°F to 54°F (+/- 5°F ). . The display usually shows the average temperature of the appliance at that moment. NORMAL TEMPERATURE SETTING: Whenever the appliance is switched on, or the NORMAL' pad is pressed, the appliance runs on the 'NORMAL' setting of 45°F and the 'NORMAL' indicator lights. MANUAL TEMPERATURE SETTING: The temperature of the beverage cooler can be set anywhere between 41°F to 54°F by the temperature up and temperature down pads as follows: (1) Press the [SET] pad until you hear a "beep" (approximat (2) Press the pads to increase or decrease the desired temperature in increments of one degree. (3) Press the [SET] pad to confirm your choice - if confirmation is not made within ten seconds the unit will go back to the previous setting. The 'MANUAL' indicator lights when the appliance runs on 'MANUAL' setting. The temperature display can be changed between Celsius and Fahrenheit by pressing and holding the pad for approximately 10 seconds. The following is applicable to both MCWC50DBT and MCBC580DBT: To return the controller back to the Factory Setting, press and hold the pad, within one second press pad and continue holding both for approximately 10 seconds, until you hear a "beep" sound signaling that the controller is back to the original Factory Setting. The indicator indicates status of the refrigeration cycle as follows: (1) It flashes before the compressor starts; (2) It remains ON during the refrigeration cycle; (3) It remains OFF during the idle cycle. 5 Maintenance and Cleaning Automatic Defrosting of the Appliance There is no need to defrost the appliance, because ice depositing on the inner back wall is defrosted automatically. Ice build-up on the inner back wall during the compressor operation will defrost automatically (when the compressor has cycled off) . Defrost water will drain out passing through the drain outlet in the inner back wall into a drain pan situated above the compressor, from where it evaporates. Correct Steps to Change Bulb 1. [. . . ] Inside components such as door panels, door shelves, racks, light bulbs, etc. Punctures to the evaporator system due to improper defrosting of the unit. Service calls that do not involve defects in material and workmanship such as instruction on proper use of the product, door reversal or improper installation. Any delivery costs incurred as the result of a unit that fails to perform as specified. [. . . ]