User manual MAGIC CHEF MCWC45A

[. . . ] 7 VACATION TIME. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 MOVING YOUR APPLIANCE. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ENERGY SAVING TIPS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . TROUBLESHOOTING GUIDE. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Do not, under any circumstances, cut or remove the third ground prong from the power cord supplied. The cord should be secured behind the wine cooler and not left exposed or dangling to prevent accidental injury. Always grip the plug firmly and pull straight out from the receptacle. If the power cord is too short, have a qualified electrician or service technician install an outlet near the appliance. Use of an extension cord can negatively affect the performance of the unit. If any problems with the wine cooler persist, please contact our Customer Service Dept. to consult with a representative at 888 775-0202 or visit our website to request warranty service at www. mcappliance. com. 4 EN OPERATING YOUR APPLIANCE Temperature Control · Your wine cooler has one control for regulating the temperature. The temperature control is located on the top center of the wine cooler compartment. The first time you turn the unit on, adjust the temperature control knob to "7" and run for at least 2 hours before putting wine bottles inside. This will ensure the cabinet is thoroughly chilled before wine bottle is stored. The range of the wine cooler temperature control is from position "1" the warmest to "7" the coldest. Adjust the temperature control to the setting that best suits your needs. - The setting of "2" is recommended for storage of red wines. - The setting of "6" is recommended for storage of white wines. To turn off the wine cooler, please turn the temperature control knob to "0". Please note that turning the temperature control knob to "0" position stops the cooling cycle, but does not disconnect the power supply to the wine cooler. · · · WARNING: Do not set the temperature control to setting of "7" position for longer than 8 hours. If the unit is unplugged, loses power; you must wait 3 to 5 minutes before restarting the unit. If you attempt to restart before this time delay, the wine cooler will not start. · Change in ambient temperature will affect the internal temperature of the wine cooler. · If you choose to change the thermostat setting, adjust thermostat control by one increment at a time. Allow several hours for temperature to stabilize between adjustments. Changing The Inner Light Before removing the inner light, turn off the wine cooler first and then unplug the unit from the wall outlet. · Pull out the existing light bulb by unscrewing it counter-clockwise. [. . . ] Try the suggestions below to see if you can solve the problem before calling for service. PROBLEM Wine cooler does not operate. Turn the control to a cooler setting and allow several hours for the temperature to stabilize. Turn the control to a warmer setting and allow several hours for the temperature to stabilize. If continued vibration occurs, turn off the wine cooler and unplug the power plug. [. . . ]