User manual MAGELLAN NAV 1200 XL

[. . . ] From the map screen use the cursor key to move the cursor to an existing waypoint. The delete softkey will become active and the waypoint information will be displayed in the information window. Highlight yes to delete the waypoint or no if you change your mind and press enter. Use the cursor key to highlight the waypoint you wish to view and press the view softkey. [. . . ] Use the cursor key to place the cursor over the waypoint in the route that you wish to remove. The waypoint is removed from the route, however it continues to exist as a waypoint in the waypoint list and on the map. 9 Question: Answer: 10 Question: Answer: 11 Question: Answer: 12 Question: Answer: 13 Question: Answer: 14 Question: Answer: 15 Question: Answer: 16 Question: Answer: 5. How do I change the time format from 24 hours to 12 hours in my NAV6500/NAV6510?Press the aux softkey, highlight general setup using the cursor key, and press enter. Highlight time format and press enter to display a window with the options 24, 12. The receiver supports five languages: English, Italian, French, German, and Spanish. Press the aux softkey, highlight general setup using the cursor key and press enter. Highlight language, press enter and a window opens listing the languages. How do I change the co-ordinate system from deg/min/sec to deg/min/fractions?Press the aux softkey, use the cursor key to highlight navigation setup, and press enter. Use the cursor key to highlight the desired coordinate system and enter to set. Make sure that the antenna has a clear and unobstructed view of the sky. Make sure the coaxial cable is firmly secured to the back of the unit. Check along the length Answer: 28 Question: Answer: 29 Question: Answer: 30 Question: Answer: 31 Question: Answer: 32 Question: Answer: of the cable to make sure it is not cut. With a voltmeter, you may also measure the voltage output from the unit to the antenna, which should be 5 0. 25 VDC between the center conductor and the shield of the TNC connector. (You need to measure across a 100ohm resistor for correct reading. ) 3. Have you moved more than 300 miles with the receiver off since your last position fix?If the receiver status on any of the NAV screens is "no GPS, " turn the unit off and on. Select memory reset under aux and execute the "GPS reset only. " My GPS display is frozen and the keypad is not responding. Position coordinates on my GPS receiver do not match the location on the map?Make sure that your receiver is set up to use the same datum as your map. Make sure the C-card is inserted all the way into the C-card slot and locked in place. [. . . ] Cold start: the receiver has been idle for two hours or longer. 33 Question: Answer: 34 Question: Answer: 36 Question: Answer: 37 Question: Answer: 38 Question: Answer: 39 Question: Answer: 40 Question: Answer: 41 Question: What is BRG? Answer: BRG (bearing) is the direction of a point {waypoint or cursor position} in relation to a boat or another point, as measured in degrees from north in a clockwise direction. The receiver uses either true north or magnetic north, as selected in the setup menu. The illustration shows a simple compass rose with the eight cardinal directions noted with their bearing. Course over Ground (COG) is the direction of movement expressed as bearing. [. . . ]