User manual MAGELLAN 750M

[. . . ] Vehicle Navigation System Installation & Reference Addendum Vehicle Navigation Made Portable TABLE OF CONTENTS TM The Magellan 750M Vehicle Navigation Made PortableTM Precautions . Preparing Navigation Computer for 750NAV In-Vehicle Fixed Installation . . 2 2 3 4 6 6 6 7 8 9 10 13 15 15 17 18 18 18 19 19 20 21 25 25 26 27 1 PREC AUTIONS ! TIP This symbol is intended to alert the user to the presence of important operating instructions. Failure to heed the instructions can result in injury or material damage. [. . . ] Step 3: Select desired user and press ENTER to arrive at `Select Destination' screen (Main Menu). Step 6: Scroll to `Sensor Status', press ENTER. Step 7: Vehicles with automatic transmission, place foot firmly on the brake and put vehicle into drive. If using manual transmission, place foot firmly on brake and keep transmission in neutral. Step 8: Wait for the vehicle to be motionless and verify that there is a green ZMD (zero motion detected) displayed on the right center side of the screen. Step 9: Press LOCATE. `Computing new ZMD threshold' will appear on bottom of Display screen. Step 10: Wait for `Computing new ZMD threshold' to disappear (approximately 10 seconds). Step 11: Accelerate to 10-15 miles per hour, then stop. TIP The ZMD indicator disappears when the 750M detects motion. Step 12: While stopped, wait for the ZMD indicator to reappear. Now repeat the acceleration and stop process four more times. TIP For verification, the Bias LC and Orientation LC (Learn Count) numbers must increment as the system calibrates to the vehicle. 16 Step 13: Press CANCEL three (3) times to get to `Select Destination' screen and then press VIEW to get to the `Map' screen. Verify that the Direction and Signal Strength Indicator located at the bottom left corner of the Display, is green, indicating that the system has located GPS satellites. Ensure vehicle icon is correctly displayed on the Map or press LOCATE to check current location. The `Full Calibration' procedure is now complete and the 750M is ready for inputting a destination. Quick Calibration After initialization, the `Quick Calibration' function is activated upon power up. To utilize this feature, simply follow the instructions on the Display when prompted. The steps required for a `Quick Calibration' are as follows: Step 1: If the 750M is not on while the vehicle is running, turn it on by pressing the POWER button. Step 2: Select desired user and press ENTER to arrive at the `Quick Calibration' screen. Step 3: Highlight `Calibrate', press ENTER. Step 4: Follow on-screen instructions. Step 6: Verify that the Direction and Signal Strength Indicator located at the bottom left corner of the Display, is green, indicating that the system has located GPS satellites. The `Quick Calibration' procedure is now complete and the 750M is ready for inputting a destination. For further instructions, consult the 750NAV User Manual. 17 OPERATIONS Battery Charger The Battery Charger provides power to the 750M and charges the Battery only during 750M operation. It also incorporates a Battery Test Circuit that allows the user to check the charge on the Battery. Using the `BATTERY TEST' Button and reading the five (5) multi-colored Battery Status Indicators, a user can determine the state of the Battery, from `LOW' to `100%'. [. . . ] Following the suggestions below will ensure maximum functionality and enjoyment of the 750M. · Most common multi-purpose cleaners will not harm the Display or Navigation Computer unit. DO NOT spray cleaner directly onto the Display; apply cleaner to a cloth first and then wipe the Display with dampened cloth. Harsh chemicals such as those found in hair spray, insect repellent and nail polish can damage the Display lens. [. . . ]