User manual M-SYSTEM MVW681

[. . . ] MVW 681 Bedienungsanleitung Geschirrspüler instruction book dishwasher Seite 2 page 23 Contents Safety instructions Disposal Economical and ecological dishwashing Installation instructions Building-in Levelling Fixing to adjacent units Water supply connections Water inlet hose with safety valve Water outlet hose connection Electrical connection Description of the appliance The control panel Audible signals Prior to using for the first time Setting the water softener Filling with dishwasher salt Rinse aid In daily use Loading cutlery and dishes The lower basket The cutlery basket Removable knife basket The upper basket Adjusting the height of the upper basket Use of detergent Different kinds of detergent Washing programmes Starting a washing programme 24 24 24 25 25 25 25 25 25 26 26 27 28 29 30 30 31 32 33 33 33 34 34 34 35 35 36 37 38 Maintenance and cleaning Cleaning the filters Prolonged periods of non-operation Frost precautions Moving the machine What to do, when. . . Service and spare parts Hints for test centres 40 40 40 40 40 41 42 43 Technical specifications Dimensions Width Height Max depth Max depth with open door 59. 6 cm 81. 8 - 87. 8 cm 55. 5 cm 114 cm Electrical connection: Voltage Overall power Fuse Water supply pressure Information on the electrical connection is given on the rating plate on the inner edge of the dishwasher's door. Minimum Maximum 50 kPa (0. 5 bar) 800 kPa (8 bar) 12 place settings Capacity This appliance complies with the following E. E. C. Directives: - 73/23 or 19. 2. 73 (Low Voltage Directive) and subsequent modifications; - 89/336 or 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. 23 Safety instructions It is most important that this instruction book should be retained with the appliance for future reference. [. . . ] The maximum level for filling is indicated by "max". Deactivation/activation of the rinse aid dispenser (The dishwasher must be switched off) Factory setting: rinse aid dispenser activated When the rinse aid dispenser has been deactivated, also the rinse aid indicator light on the control panel is automatically deactivated. The indicator lights of the programme selection buttons will illuminate and in the digital display are visible 2 horizontal lines (--) (setting mode). If other button indicator lights are on and in the digital display is visible the number of a programme (1 - 2 - 3 etc. . ), this means that a washing programme has been set. The programme must be cancelled: press the button Cancel for about 3 seconds. The indicator lights of the programme selection buttons will illuminate and in the digital display will appear 2 horizontal lines, this means that the set washing programme has been cancelled and the machine is now in setting mode. Press simultaneously function buttons 2 and 3, the indicator lights of the function buttons 1, 2 and 3 start flashing. Press the function button 2, the indicator lights of function buttons 1 and 3 turn off while the indicator light of the button 2 goes on flashing, the digital display indicates the current setting. Rinse aid dispenser deactivated Rinse aid dispenser activated (factory setting) 4. To change the setting, press again the function button 2, the digital display indicates the new setting. To memorise the operation, switch off the dishwasher by pressing the On/Off button or wait about 60 seconds after which the dishwasher will automatically return to setting mode. Ensure that the lid is closed after every refill. Clean up any rinse aid spilt during filling with an absorbent cloth to avoid excess foaming during the next wash. This would damage the appliance. Adjusting the dose According to the finish and drying results obtained, adjust the dose of rinse aid by means of the 6 position selector (position 1 minimum dosage, position 6 maximum dosage). Increase the dose if there are drops of water or lime spots on the dishes after washing. Reduce it if there are sticky whitish streaks on the dishes or a bluish film on glassware or knife blades. Top up the rinse aid when the indicator light on the control panel illuminates. 32 In daily use q Check if it's necessary to refill with dishwasher salt or rinse aid Load cutlery and dishes into the dishwasher. Start the wash programme. Loading cutlery and dishes Sponges, household cloths and any object that can absorb water may not be washed in the dishwasher. q q q q q Before loading the dishes, you should: - Remove large left-overs. - Soften remnants of burnt food in pans When loading the dishes and cutlery, please note: - Dishes and cutlery must not impede the rotation of the spray arms . with the opening downwards so that water cannot collect in the container or a deep base. - Dishes and items of cutlery must not lie inside one another, or cover each other. Plastic items and pans with teflon have a tendency to retain water drops; these items will not dry as well as porcelain and steel items. q q For washing in the dishwasher the following cutlery/dishes are not suitable: - Cutlery with wooden, horn, china or mother-of-pearl handles - Plastic items that are not heat resistant - Older cutlery with glued parts that is not temperature resistant - Bonded cutlery items or dishes - Pewter or copper items - Lead crystal glass - Steel items subject to rusting - Wooden platters - Items made from synthetic fibres are of limited suitability: - Only wash stoneware in the dishwasher if it is specifically marked as being dishwasher-safe by the manufacturer. - Glazed patterns may fade if machine washed frequently - Silver and aluminium parts have a tendency to discolour during washing. egg white, egg yolk and mustard often cause discolouring and staining on silver. Therefore always clean left-overs from silver immediately, if it is not to be washed straight after use. [. . . ] The water inlet hose has not been correctly laid or it is bent or squashed. The water drain hose has not been correctly laid or it is bent or squashed. Anti-flood device has activated. The machine does not fill with water. - in the digital display appears The dishwasher will not drain. - in the digital display appears Close the water tap and contact your local Service Force Centre. Once the checks have been carried out, to continue press one of the programme selection buttons and close the door. [. . . ]