User manual M-SYSTEM MVW651

[. . . ] Safety information Product description Control panel First use Set the water softener Use of dishwasher salt Use of rinse aid Daily use Load cutlery and dishes Use of detergent Select and start a washing programme 45 46 47 48 48 49 50 51 52 54 55 Subject to change without notice Unloading the dishwasher Washing programmes Care and cleaning What to do if. In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features. Save these instructions and make sure that they remain with the appliance if it is moved or sold, so that everyone using it through its life will be properly informed on appliance use and safety. [. . . ] Forks and spoons should be placed in the removable cutlery basket with the handles facing downwards and the knives with their handles facing upwards. If the handles protrude from the bottom of the basket, obstructing the lower spray arm, load the cutlery with the handles facing upwards. For best results we recommend that you use the cutlery grid provided (if the size and dimensions of the cutlery allow it). Before closing the door, ensured that the spray arms can rotate freely. Adjusting the height of the upper basket If washing very large plates you can load them in the lower basket after moving the upper basket to the higher position. Arrange items on and underneath the cup racks so that water can reach all surfaces. Carefully lift both sides upwards until the mechanism is engaged and the basket is stable. Setting and starting the programme with delay start The start of the washing programme will be delayed by 3 hours. Once the door is closed the countdown will continue from the point at which it was interrupted. Close the door; the programme will start from the point at which it was interrupted. cancel a washing programme in progress · Open the dishwasher door; press the programme selection/cancel button for about 3 seconds, until the light of the running programme goes off and the End indicator light flashes. If a new washing programme is to be selected, check that there is detergent in the detergent dispenser. Leave the dishwasher door ajar and wait a few minutes before removing the dishes; in this way they will be cooler and the drying will be improved. The dishes should therefore be allowed to cool down before removing from the appliance. ⷠEmpty the lower basket first and then the upper one; this will avoid water dripping from the upper basket onto the dishes in the lower one. ⷠWater may appear on the sides and the door of the dishwasher as the stainless steel will eventually become cooler than the dishes. When the washing programme has finished, it is recommended that the dishwasher is unplugged and the water tap turned off. Programme Degree of soil Type of load Programme description Prewash Main wash up to 70°C Crockery, cutlery, 2 intermediate rinses pots and pans Final rinse Drying Prewash Main wash up to 65°C Crockery, cutlery, 2 intermediate rinses pots and pans Final rinse Drying Crockery and cutlery Main wash up to 60°C Final rinse Prewash Main wash up to 50°C 1 intermediate rinse Final rinse Drying 1 cold rinse (to avoid food scraps from Partial load (to be sticking) completed later in This programme does not require the use the day). This is the perfect daily programme, made to meet the needs of a family of 4 persons who only wish to load breakfast and dinner crockery and cutlery. The consumption values are intended as a guide and depends on the pressure and the temperature of the water and also by the variations of the power supply and the amount of dishes. Cleaning the filters The filters must be checked and cleaned from time to time. Turn the handle about 1/4 a turn anticlockwise and remove the filter system 4. [. . . ] Therefore the water inlet hose is only under pressure while the water is running. If the water inlet hose starts to leak during this operation, the safety valve cuts off the running water. Please take care when installing the water inlet hose: · the electrical cable for the safety valve is in the double-walled water inlet hose. A water inlet hose with safety valve must only be replaced by the Service Force Centre. [. . . ]