User manual M-AUDIO EVOLUTION UC16

[. . . ] It will receive data from the USB port of the computer and pass this data on to the connected device. It can not transmit data from a connected device to the computer. Turn on the POWER switch. Turn all other equipment on. 3. Assignable Rotary controllers There are 16 assignable controllers selected by the CONTROL SELECT & CONTROL ASSIGN functions. [. . . ] This ensures that when the controller if first moved it does not trigger a large jump from it's previous setting. During the data entry stage while the LED display is flashing, the Knobs, do not function. 4. Entering Numbers When any number is entered it adheres to the following rules:Increment/Decrement Keys Initially the LED display starts flashing. The value displayed can be incremented/decremented using the +/- keys. Pressing both + & - should call up the default value for that parameter. The new value is sent out except for the CONTROL ASSIGN which sends data when the display stops flashing) When the display stops flashing the keyboard returns to normal operation. As each key is pressed the display continues to flash, the time-out value is reset. When a complete number* has been entered the display stops flashing and the value is selected. Alternatively, if no key is pressed and the display stops flashing the number on the display is selected. When the display stops flashing the keyboard returns to normal operation. * The following table shows how many keys are required to enter a complete number:Channel Memory Control Select Control Assign 1 key 2-9 0-9 2-9 2 keys 01, 10-16 01, 10-14 14-99 000-013, 100-132 3 keys 5. Snap Shot When both SNAP SHOT keys are pressed the UC-16 sends out the settings for all of the Assignable Controllers. The settings will be sent out on whichever channel each rotary dial is assigned to (see channel assignment later). This feature lets you record the settings of the Knobs into your sequencer. Set the UC16 to all parameter levels you desire, engage record mode on your sequencer and press the SNAP SHOT buttons. 6. Memory banks and Presets There are 25 memory banks in total. Memory banks 1-4 are accessible using the Preset buttons 1-4 respectively. This allows you to store settings you use a lot and makes for easy access to them. The rest of the memory banks are accessible by pressing the RECALL button, then using either the +/- buttons or the numeric keys to type in the number of the memory bank you want (1-25). Waldorf PPG wave 2V 10. Propellerhead's Rebirth Master 11. Propellerhead's Rebirth Rhythm section 12. Reason Subtractor 13. Reason Dr. 18. cc numbers 75 ­ 90 19. cc numbers 102 ­ 117 20. Volume (cc7) on channels 1 ­ 16 21. Pan (cc7) on channels 1 ­ 16 Bank numbers 22 ­ 25 have the same default as bank number 4. [. . . ] The status of MIDI OUT FROM USB will be saved in non-volatile memory and restored when the UC16 is switched on again. Control: Switches: (CHANNEL ASSIGN, MEMORY, CONTROL ASSIGN, CONTROL SELECT, POWER ON/OFF, Numeric Keys (0-9), PRESET BUTTONS 1-4, + AND - KEYS) 3. Rotary Controls: 16 rotary controls with assignable controller and channel values 5. [. . . ]