User manual LUXMAN D-107U SERVICE MANUAL

[. . . ] Adjust the tabs according to the thickness of the cabinet side panel, as shown below: thickness of 20 mm: take off the removable part of the tab (see diagram) 48 15 555 0 +4 560 +4 -0 thickness of 18 mm: use the first groove, which has already been set in the factory (see diagram) 39 575-585 min in 595 thickness of 16 mm: use the second groove (see diagram) 23 572 558 min 595  The appliance must not come into contact with electrical parts once it has been installed. The consumption indications on the data plate have been calculated for this type of installation. 54 5 3 45 m Secure the appliance to the cabinet by opening the oven door and putting 4 screws into the 4 holes of the outer frame.  All parts which ensure the safe operation of the appliance must not be removable without the aid of a tool. [. . . ] Declared energy consumption for Forced convection Class – heating mode: > Multi-cooking. This appliance conforms to the following European Economic Community directives: 73/23/EEC of 19/02/73 (Low Voltage) and subsequent amendments; - 89/336/EEC of 03/05/89 (Electromagnetic Compatibility) and subsequent amendments; - 93/68/EEC of 22/07/93 and subsequent amendments. - 2002/96/EC GB 15 Description of the appliance GB Overall view Control panel GUIDES for the sliding racks position 5 position 4 position 3 position 2 position 1 GRILL DRIPPING PAN Control panel EXTENDABLE HOTPLATES Knob HOTPLATES indicator light THERMOSTAT indicator light 0 12 11 10 9 8 7 2 3 4 5 6 12 11 10 9 8 7 1 12 2 3 4 5 6 11 10 9 8 7 2 3 4 5 6 12 11 10 9 8 7 1 2 3 4 5 6 180 MAX 60 220 100 140 HOTPLATES Knob THERMOSTAT knob SELECTOR Knob 16 Start-up and use  The first time you use your appliance, heat the empty oven with its door closed at its maximum temperature for at least half an hour. Ensure that the room is well ventilated before switching the oven off and opening the oven door. The appliance may produce a slightly unpleasant odour caused by the burning away of protective substances used during the manufacturing process. Cooling ventilation In order to cool down the external temperature of the oven, some models are fitted with a cooling fan that blows out air between the control panel and the oven door. Once the cooking has been completed, the cooling fan remains on until the oven has cooled down sufficiently. See the Cooking advice table for cooking modes and the suggested cooking temperatures (see Cooking Modes). The THERMOSTAT indicator light indicates that the oven is heating up to the temperature set. You may do the following during cooking: - change the cooking mode by turning the SELECTOR knob - change the temperature by turning the THERMOSTAT knob - stop cooking by turning the SELECTOR knob to the “0” position.  Never put objects directly on the oven bottom to avoid damaging the enamel coating. Practical advice on using the glass ceramic hob The glue that is applied on the gaskets leaves some traces of grease on the glass. Before using the appliance, we recommend you eliminate these with a special nonabrasive cleaning product. During the first few hours of use there may be a smell of rubber which will disappear very quickly. To obtain the best results with your hob: Extendable cooking zones • The lowest power level can be set by turning the knob clockwise from 1 to 9. • Turn the knob to completely ()) until you hear a ) slight click, to enable the maximum power level, which in turn can be adjusted between 9 and 1 by turning the knob anticlockwise. To restore the minimum power level, turn the knob and set it back to position 0. For double cooking zones, the first part of the knob movement activates the smaller cooking zone (internal). To activate both (internal and external), it is necessary to turn the knob completely ()) and then ) select the desired power level between 9 and 1. Residual heat indicator lights * The extendable radiant elements (B) are recognisable by the fact that they have a double heating zone. You can turn on only the smaller internal cooking zone or both the external and internal zones. The control knob allows you to choose between two power levels, which are both adjustable between a minimum value of 1 to a maximum of 9: • Use flat-bottomed pans to ensure that they adhere to the cooking zone perfectly. [. . . ] 21 Maintenance and care GB Switching the appliance off Disconnect your appliance from the electricity supply before carrying out any work on it. Inspecting the seals Check the door seals around the oven periodically. If the seals are damaged, please contact your nearest After-sales Service Centre (see Assistance). Cleaning the appliance • The stainless-steel or enamel-coated external parts as well as the rubber seals may be cleaned using a sponge that has been soaked in lukewarm water and neutral soap. [. . . ]