User manual LOWRANCE X-15 OPERATION MANUAL

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual LOWRANCE X-15. We hope that this LOWRANCE X-15 user guide will be useful to you.


LOWRANCE X-15 OPERATION MANUAL: Download the complete user guide (506 Ko)

Manual abstract: user guide LOWRANCE X-15OPERATION MANUAL

Detailed instructions for use are in the User's Guide.

[. . . ] Paper Saving Feature WithoutAlternate Transmit and Print Minimum Paper Speed RANGE (feet) 10-120 130-510 520-830 Below 840 Inches Per Mm 1. 0 INSTALLATION AND OPERATION MANUAL APPROXIMATE PAPER SPEED MODEL X-15 GRAPH RECORDER Hours Per Roll 10 0. 5 0. 2 0. 2 20 50 50 -- Maximum Paper Speed Inches Hours Per Mm Per Roll 3. 0 3. 3 2. 0 5. 0 1. 2 0. 75 8. 3 13. 3 APPROXIMATE PAPER SPEED With Alternate Transmit and Print Minimum Paper Speed Inches Hours Per Mm Per Roll 0. 6 17 25 0. 4 0. 2 50 0. 2 50 Maximum Paper Speed Inches Hours Per Mm Per Roll 2. 0 5. 0 1. 2 RANGE (feet) 10-120 130-510 520-830 Below 840 0. 75 0. 75 8. 3 13. 3 13. 3 LITHO USA 988-0083-01 · LOWRANCE ELECTRONICS, INC. 12OOO E. 74128 PDF compression, OCR, web-optimization with CVISION's PdfCompressor I! E'l L 30 U RANGE:10-30 FEET SENSITIVITY: 3/4 SUPPRESSOR: MINIMUM PAPER SPEED: 3/4 GRAYLINE: MINIMUM Figure 50 ft 1 -i :4 5 U, RANGE: 10-30FEET SENSITIVITY: 3/4 SUPPRESSOR: MINIMUM JO PAPER SPEED: MAXIMUM GRAYLINE: MINIMUM Figure 51 A & I- A L RANGE: 10-30 FEET SENSITIVITY: MAXIMUM SUPPRESSOR: MINIMUM & NEAR BOTTOM UNDER SCHOOL OF SMALLERFISH NOTE LARGER FISH ON Figure 52 PDF compression, OCR, web-optimization with CVISION's PdfCompressor 25 INDEX Introduction How It Works Installation Transducer Selection Basic Operation Suppressor Paper Speed SUPPRESSOR: MINIMUM SENSITIVITY: 3/4 2 2 3 4 5 S RANGE:0-40 FEET . 7 LINES:OFF PAPER SPEED:3/4 Figure 47 GRAYLINE® Range Lower Limit Upper Limit Lines Marker Scale End Of Paper How To Read Graphs Paper Loading Stylus Replacement Do's and Dont's 7 7 8 8 9 9 9 10 10 10 12 15 17 17 17 17 18 18 18 RANGE: 0-30 FEET SUPPRESSOR: MINIMUM SENSITIVITY: 3/4 LINES: ON PULSEWIDTH:100 MICRO-SECONDS PAPER SPEED: MAXIMUM Figure 48 Troubleshooting Advanced Operation Surtace Clarity Control (SCC) Feet, Fathoms, Meters Transmit and Print Alternate ' Transmitter Pulse Width Specifications Service Information 22 22 . RANGE:10-50 FEET SENSITIVITY: MAXIMUM SUPPRESSOR: MINIMUM PAPER SPEED: 3/4 LARGE SCHOOLOF FISH AT 12 TO 26 FEET Figure 49 24 PDF compression, OCR, web-optimization with CVISION's PdfCompressor The Lowrance X-15 is a highly sophisticated recording depth sounder. Thanks to a microcomputer, the X-15 can do more than any other depth sounder in its price range. Full control of the system is at your finger tips to meet the changing demands of varying bottom conditions, waterdepth and boat speed. [. . . ] Although the unit will revert back to the feet mode whenever power is turned off, it is simple to change to any mode you wish by pressing 1 and 3 for feet -- 4 and 6 for fathoms, and 7 and 9 for meters. When the unit is in the Feet mode, only one L' will be displayed at the bottom of the chart paper every few inches. Example: Display Meters Press: 7 and 9 simultaneously Result: Figure 41 U C-- -- U -- a 12 -- lb Ib-- 20-- By looking at the numberof U 's, one can determine the depth display mode that the unit is in, i. e. , Feet - U Fathoms U LL or Meters - I. !Transmit and Print Alternate When using the X-15 in deep 18 water, it may be desirable to slow the paper speed down considerably. However, when doing so, you may get "over print" or very dark, heavy printing over an area that is difficult to read. A feature that the X-15 makes available is the Transmit and Print Alternate which, when activated, causes the stylus to print every other revolution instead of every revolution. Since the stylus only prints every other revolution, the recorded information is not squeezed together into a very small area. Also, the scale numbers are spread out more, so they are more legible. This is the undesirable occurrence of the second or third bottom echo printed on the paper at the top or middle of the page. Many times this can interfere with fish or other targets that you wish to see. This happens mainly on lower frequency units, although it does sometimes show up on high frequency graphs. To use the Transmit and Print Alternate function, press the UPPER and LOWER keys simultaneously. If you wish to turn the function off, simply press the UPPER and LOWER keys again. pared to real sonar signals. Advancingthe Suppression knob will cause the system to reject these unwanted, short pulses without reducing the sensitivity in any way. However, with high suppression settings, the graph record becomes coarse and the ability to separate fish from the bottom or from other fish will be decreased. (See Figure 10. ) Therefore, the lower the suppression setting, the better. Advance the knob setting only as far as RD chart paper when operating in deep water The chart below gives the points where the maximum speed of the paper is slowed. PAPER SPEED 1 Fastest paper speed 2 Medium fast 130'-510' paper speed 52O83O 3 Medium slow paper speed 4 Slowest paper Below 840' speed The chart paper may be slowed RANGE 10'-120' I® I lirf P, , " . I) 2 : Figure 9 PROPER SETrING necessary to remove the erratic, unwanted noise marks. Most of the time at low or trolling speeds, no suppression will be needed. Paper Speed Control This knob adjuststhe speed of the chart paper. For good detailed graphs, in shallow to medium depths, turn the paper speed control up to at least ¾ when trolling. This will show proper fish arches at low speeds and Transmit Pulse Width The noise suppression system in the X-15 is a patented pulse width discrimination suppression circuit, and is the same as the one keeps high speed information from being compressed. The paper speed should be turned down when using the unit in deep water This will prevent gap from appearing in the record. In fact, the microcomputer will automatically slow the maximum speed of the Figure 10 SUPPRESSION: TOO HIGH even further by adjusting the paper speed control. [. . . ] When the fish has moved to the center of the cone, the distance to it will be shorter, (line "B"), and as it moves out of the cone, the distancewill increase again as shown in line "C". Figure 22 "Arched Signatures" Figure 37 - U PDF compression, OCR, web-optimization with CVISION's PdfCompressor 15 0-- 10 -- 20 -- 30 -- 40 -- 50 -- 60 Figure 23 tion of a warm and cool layer of water is called a thermocline. The depth and thickness of the thermoclinecan vary with the season or time of day. Thermoclines are important to the fishermanbecause they are areas which fish are active. Many times bait fish will be above the thermoclinewhile larger game fish suspend just below it. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE LOWRANCE X-15




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual LOWRANCE X-15 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.