User manual LOWRANCE NMEA 2000 BUSS ADAPTER CABLE

[. . . ] 988-0154-141 NMEA 2000 Buss Adapter Cable and Micro-C T-shaped Connector Installation Instructions These instructions will help you connect a Lowrance or LEI product to an installed NMEA 2000 network with Micro-C connectors. To do so, you will need an adapter cable of one of the following types: To NMEA 2000 network port Micro-C to Lowrance Male converter. [. . . ] Either method will leave one new port available. LEI Buss adapter cable needs an open port. Replace terminator at the very end of the buss. Existing network port with attached sensor Add an empty network port to a NMEA 2000 buss by attaching a Tshaped connector between two full ports, or between a port and the terminator at the end of the line. Attach the adapter cable's Micro-C connector to the new port, and the other connector to your Lowrance or LEI product. Connecting Lowrance Male Plug to Unit or Sensor Most installations will use the Lowrance Male to Micro-C converter to connect a Lowrance or LEI product directly to a network port. To connect a sonar or GPS or sonar/GPS combo unit directly to a NMEA 2000 network, attach the adapter cable's Lowrance Male plug to the Network socket on the back of the unit. Network socket NMEA 2000 buss with open port Buss adapter cable Attach cable to Network socket on back of unit Use the buss adapter cable to connect a Lowrance unit to a network port. 2 To connect an LEI sensor or GPS module directly to the network, attach the accessory's blue connector to the adapter cable's Lowrance Male plug. NMEA 2000 speed sensor NMEA 2000 buss with open port Buss adapter cable LGC2000 NMEA 2000 temp sensor Use the buss adapter cable to connect any NMEA 2000-ready LEI or Lowrance accessory to a network port Connecting Lowrance Female Plug to Extension Cable With some NMEA 2000-ready GPS modules we provide a Y-adapter extension cable that will allow you to connect both the GPS unit and the GPS module to a single NMEA 2000 network port. Connect the GPS module to the unit using the extension cable as described in the unit's manual. To Network socket on back of unit LGC2000 Buss adapter cable NMEA 2000 buss with open port 25' Y-adapter extension cable LGC-2000 and GPS unit connection to NMEA 2000 buss. The GPS module's extension cable will have a 60-ohm terminator attached to the shorter branch. Remove the terminator and connect the adapter's Lowrance Female plug to the extension cable's shorter branch. If you do this, be sure the unit's NMEA 2000 Power cable is not connected to your boat's power supply. If it's working, it's already powered, and a NMEA 2000 network should never be connected to more than one power source. If you ever disconnect the NMEA 2000 network connection, you'll have to re-attach the terminator in order for the GPS module to function correctly. 3 How to Obtain Service. . . . . . in the USA: Contact the Factory Customer Service Department. Central Standard Time, M-F Lowrance Electronics and Eagle Electronics may find it necessary to change or end their shipping policies, regulations and special offers at any time. They reserve the right to do so without notice. . . . in Canada: Contact the Factory Customer Service Department. Eastern Standard Time, M-F 800-661-3983 . . . outside Canada and the USA: Contact the dealer in the country where you purchased your unit. To locate a dealer near you, see the instructions in paragraph number 1 below. Accessory Ordering Information LEI Extras, Inc. [. . . ] Eastern Standard Time, M-F. For Lowrance and Eagle Products Pub. 988-0154-141 Printed in USA 031804 © Copyright 2004 All Rights Reserved LEI Extras, Inc. 4 [. . . ]