User manual LOWRANCE LMS-334C IGPS

[. . . ] 988-0152-111 www. lowrance. com LMS-334c iGPS & LMS-339cDF iGPS Fish-finding Sonar & Mapping GPS Installation and Operation Instructions Copyright © 2006 Lowrance Electronics, Inc. No part of this manual may be copied, reproduced, republished, transmitted or distributed for any purpose, without prior written consent of Lowrance Electronics. Any unauthorized commercial distribution of this manual is strictly prohibited. Lowrance is a registered trademark of Lowrance Electronics, Inc. Navionics is a registered trademark of Navionics, Inc. eXitSource Database, copyright 2001-2005 Zenrin Co. [. . . ] The depth indicators now accurately show the water depth from surface to bottom. 77 Sensitivity & Auto Sensitivity The sensitivity controls the ability of the unit to pick up echoes. A low sensitivity level (from zero to 50 percent) excludes much of the bottom information, fish signals, and other target information. High sensitivity levels let you see this detail, but it can also clutter the screen with many undesired signals. Typically, the best sensitivity level shows a good solid bottom signal with Colorline and some surface clutter. When the unit is in the automatic mode, sensitivity is automatically adjusted to keep a solid bottom signal displayed, plus a little more power. However, situations occur when it becomes necessary to increase or decrease the sensitivity. This typically happens when you want to see more detail, so an increase in sensitivity is indicated. Or, wave action and boat wakes can create enough tiny air bubbles to clutter much of the water column. In that case, a decrease in sensitivity is indicated to reduce some of the clutter. The control bar used to adjust sensitivity up or down is the same whether the unit is in the automatic or manual mode. In automatic you can adjust sensitivity up to 100 percent but the unit will limit your minimum setting. In auto, the unit will continue to make small adjustments, allowing for the setting you selected. In manual mode, you have complete control over sensitivity, with the ability to set it anywhere from zero to 100 percent. Once you select a level in manual, the unit will continue to use that exact sensitivity setting until you change it or revert to auto mode. When it's set at the desired level, press EXIT. Tip: For quicker sensitivity adjustments, try leaving the Sensitivity Control Bar on the screen as the chart scrolls. You can see the changes on the screen as you press the up or down arrows. This is handy when there's a lot of clutter in the water, and you are matching the sensitivity to rapidly changing water conditions. The Sensitivity Control Bar (right). To adjust sensitivity in manual mode: 1. First, turn off Auto Sensitivity: from the Sonar Page, press MENU| to AUTO SENSITIVITY|ENT. NOTE: To reset Auto Sensitivity to the default setting, see the entry in this section on Reset Options. In manual mode, Reset Options will switch sensitivity back to Auto, its factory default setting. Sonar Chart Mode The default color scheme for the sonar chart is the white background, but we offer other variations to suit your viewing preferences. [. . . ] If you're in the United States and you have technical, return or repair questions, please contact the Factory Customer Service Department. Before any product can be returned, you must call customer service to determine if a return is necessary. Many times, customer service can resolve your problem over the phone without sending your product to the factory. To call us, use the following toll-free number: 800-324-1356 8 a. m. [. . . ]