User manual LOWRANCE IWAY-600C

[. . . ] 988-0160-191 Turn-by-Turn Mapping GPS and MP3 Player Operation Instructions Copyright © 2007 Lowrance Electronics, Inc. No part of this manual may be copied, reproduced, republished, transmitted or distributed for any purpose, without prior written consent of Lowrance. Any unauthorized commercial distribution of this manual is strictly prohibited. Lowrance® is a registered trademark and iWAYTM is a trademark of Lowrance Electronics, Inc. [. . . ] To disable Safety Mode and switch to Passenger Mode make sure the vehicle is not moving. When this feature is selected a dialog box will appear stating, "Only Passengers should disable Safety Mode. Never enter data or configure your iWAY while operating a motor vehicle. Disable safety mode?" Select YES or NO to turn this feature on or off. 36 The red X on the Safety Mode button (left) indicates the feature is turned off. The disable Safety Mode Warning dialog box is shown at right. WARNING: When a GPS unit is used in a vehicle the vehicle operator is solely responsible for operating the vehicle in a safe manner. Vehicle operators must maintain full surveillance of all pertinent driving conditions at all times. An accident or collision resulting in damage to property, personal injury or death could occur if the operator of a GPSequipped vehicle fails to pay full attention to travel conditions and vehicle operation while the vehicle is in motion. Do not attempt to configure, adjust or enter information into your GPS unit while driving. Sound and Voice Setup Much of the information you will receive from the unit will come in the form of sounds. Use the Sound and Voice Setup menu to adjust the type and frequency of audio output the unit provides. Press inside the box to the left of each feature to check it (turn on) and uncheck it (turn off). 37 Key Sounds: When this feature is on the unit will emit a sound every time you enter a command. Voice Instructions: If you turn off Voice Instructions, voice instructions can still be accessed by pressing the SPEAK button on the map screen. Verbose Mode: This feature will cause the unit to give slightly more de- tailed spoken navigation instructions. Read Street Names: When this feature is active the unit will tell you the name of the streets you navigate. Read Distances: When this feature is active the unit will tell you the distance to your next turn. FM Modulator On: This feature controls the FM Modulator in the Music Screen. The feature must be checked for the FM Modulator to work. Music Volume: This setting only affects music playback; spoken instruc- tions will remain unchanged. Periodic Voice ­ 20 min: Use this feature to increase or decrease the frequency of spoken instructions. Periodic Voice instructions are repeated at set intervals and are intended as reminders. Voice Volume: This setting only affects spoken instructions; your music volume will remain unchanged. Music Volume: This setting controls all audio output. Interface Options The Interface Options menu allows you to control the visual display of the unit, including brightness and transparency. You can also use Interface Options to access the Calibrate Screen feature in case the unit's touch screen isn't responding precisely. Small target icon The Interface Options menu, left, and the Touch Screen Calibration feature, at right. 38 Interface Selection Interface Selection allows you to change the unit's visual appearance. To change the unit's current skin display, press the arrow key under the Interface Selection header and a drop-down box will appear showing all of the available skins. Choose a skin from the list and the unit will display the new skin automatically. Screenshots throughout this manual were taken using the "Default" skin mode. [. . . ] SKELLY DRIVE, TULSA, OK 74128 (800) 324-1356 83 How to Obtain Service. . . . . . in the USA: We back your investment in quality products with quick, expert service and genuine Lowrance parts. If you're in the United States and you have technical, return or repair questions, please contact the Factory Customer Service Department. Before any product can be returned, you must call customer service to determine if a return is necessary. Many times, customer service can resolve your problem over the phone without sending your product to the factory. [. . . ]