User manual LOWRANCE IFINDER HUNT C

[. . . ] 988-0148-771 Handheld Color GPS Receiver Operation Instructions Copyright © 2005 Lowrance Electronics, Inc. No part of this manual may be copied, reproduced, republished, transmitted or distributed for any purpose, without prior written consent of Lowrance. Any unauthorized commercial distribution of this manual is strictly prohibited. iFINDER HUNTc is a trademark and iFINDER and Lowrance® are registered trademarks of Lowrance Electronics, Inc. [. . . ] If no MMC is present, you must first insert a card into the iFINDER in order to activate the Load or Save commands. Loading: There may be more than one GPS Data File (*. USR) on the card. To select a file, press ENT to activate the selection box, use or to highlight the file, then press ENT to accept the selection. The unit will display a completion message when the data transfer is finished. To return to the Page view, press EXIT|EXIT|EXIT. Navigate Navigation is one of the most powerful reasons for owning an iFINDER. With the navigation options available you can get accurate information about where you want to go, how to get there, how long it will take and other useful trip information. Navigate Back Home You can navigate to the Home waypoint created in Easy Mode, but you must use Advanced Mode's procedure for navigating to a waypoint. Navigate Back to Man Overboard Waypoint This unit has a man overboard feature that shows navigation data to the location where the feature was activated. Your position at the time these keys are pressed is used as the man-overboard position. 3, Easy Mode Operation. 56 Cancel Navigation In Advanced Mode Press MENU|MENU| to CANCEL NAVIGATION|ENT. From the NAVIGATION PAGE, press MENU|ENT or from the MAP PAGE, press MENU|MENU| to ROUTE PLANNING|ENT. Use arrow keys to center cursor crosshairs over a map object or location. Follow steering arrow on Map Page or compass bearing arrow on Navigation Page. Navigate to an Icon Use the Navigate to Cursor command above, and use the cursor to select the icon. Navigate to Point of Interest (POI) For POIs that are in view on the map, you can easily use the Navigate to Cursor command above. 6, Searching, for detailed instructions on POI searches. ) Whenever you locate a POI, the Point of Interest information screen appears (with phone number, position, etc. ) and the GO TO command is automatically highlighted in the command box. To navigate to that POI, press ENT and the iFINDER begins displaying navigation information to that location. Navigate to a Waypoint You can select any waypoint visible on the Map Page with the cursor, then use the Navigate to Cursor command. You can avoid scrolling the map to pick your waypoint, if you use the Find commands. To look up the nearest waypoint, press ENT, or to look by name (and scroll through the entire waypoint list), press TO FIND BY NAME|ENT. If your waypoint list is a long one, you can spell out the waypoint name in the FIND BY NAME box. (Press or to change the first character, then press to move the cursor to the next character and repeat until the name is correct, then press ENT to jump to the list below. ) 57 3. [. . . ] If you're in the United States and you have technical, return or repair questions, please contact the Factory Customer Service Department. Before any product can be returned, you must call customer service to determine if a return is necessary. Many times, customer service can resolve your problem over the phone without sending your product to the factory. To call us, use the following toll-free number: 800-324-1356 8 a. m. [. . . ]