User manual LOWRANCE GLOBALMAP BAJA

[. . . ] 988-0151-231 www. lowrance. com Mapping GPS Receiver Operation Instructions Copyright © 2004 Lowrance Electronics, Inc. No part of this manual may be copied, reproduced, republished, transmitted or distributed for any purpose, without prior written consent of Lowrance. Any unauthorized commercial distribution of this manual is strictly prohibited. GlobalMap Baja and Lowrance® are registered trademarks of Lowrance Electronics, Inc. [. . . ] The unit stops showing navigation information. Navigate to Cursor Position on Map The GO TO CURSOR command: navigates to the current cursor position on the map. It's a quick and handy way to navigate to anything you can see on the map display. Use the cursor (controlled by the arrow keys) with the zoom in and zoom out keys to maneuver around the map until you find a location you want to go to. can be "selected, " and appear "highlighted" with a pop-up box. Other features, such as a river or a street intersection will not appear "highlighted, " but the cursor will take you to those locations just the same. ) Navigate to cursor. In this example, the cursor has selected the town of Oologah, Oklahoma. 43 3. Press MENU|ENT and the unit will begin navigating to the cursor location. The Map Page will display a dotted line from your current position to the cursor position. The Navigation Page displays a compass rose showing navigation information to your destination. See the following examples. The 15-mile zoom figure at left clearly shows the dotted course line connecting your current position to your destination. The 40-mile zoom, center, shows both current position and destination on screen. The Navigation Page, right, will also show navigation information. To stop navigating to the cursor, use the Cancel Navigation command: press MENU|MENU| to CANCEL NAVIGATION|ENT| to YES|ENT. The unit stops showing navigation information. Navigate to a Point of Interest For POIs that are in view on the map, you can easily use the Navigate to Cursor command above; just use the cursor to select the POI. The other method involves searching for POIs with the Find Waypoint command, launched with the WPT key. 6, Searching, for detailed instructions on POI searches. ) After you have looked up an item with the Find Waypoint command, use or to make sure the GO TO WAYPOINT command is highlighted at the top of the screen, then press ENT. To cancel navigation, press MENU|MENU| to CANCEL NAVIGATION|ENT| to YES|ENT. The unit stops showing navigation information. Creating and Saving a Trail A trail, or plot trail, is a string of position points plotted by the unit as you travel. They are 44 particularly handy when you are trying to retrace your trip and go back the way you came. On the screen, trails are represented by a solid line extending from the back of the current position arrow. The unit is set at the factory to automatically create and record a trail while the unit is turned on. The unit will continue recording the trail until the length reaches the maximum trail point setting (default is 2, 000, but the unit can record trails 9, 999 points long). When the point limit is reached, the unit begins recording the trail over itself. [. . . ] If you're in the United States and you have technical, return or repair questions, please contact the Factory Customer Service Department. Before any product can be returned, you must call customer service to determine if a return is necessary. Many times, customer service can resolve your problem over the phone without sending your product to the factory. To call us, use the following toll-free number: 800-324-1356 8 a. m. [. . . ]