User manual LOWRANCE GLOBALMAP 7000C

[. . . ] 988-0151-041 www. lowrance. com GlobalMap 7000C Mapping GPS Receiver Operation Instructions Copyright © 2002 Lowrance Electronics, Inc. Navionics is a registered trademark of Navionics, Inc. Points of Interest Data in this unit are by infoUSA, copyright 2001-2002, All Rights Reserved. infoUSA is a trademark of infoUSA, Inc. eXitSource Database, copyright 2001-2002 Zenrin Co. Ltd. Lowrance Electronics may find it necessary to change or end our policies, regulations and special offers at any time. [. . . ] The GlobalMap 7000C stops showing navigation information. Navigate to a Point of Interest For POIs that are in view on the map, you can easily use the Navigate to Cursor command above; just use the cursor to select the POI. The other method involves searching for POIs with the Find Waypoint command, launched with the WPT key. (See the searching example ear42 lier in this section, or turn to Sec. 6, Searching, for detailed instructions on POI searches. ) After you have looked up an item with the Find Waypoint command, use the to make sure the GO TO command is highlighted at the top of the screen, then press ENT. The GlobalMap 7000C begins showing navigation information to the item. To cancel navigation, press MENU|MENU| to CANCEL NAVIGATION|ENT| to YES|ENT. The GlobalMap 7000C stops showing navigation information. Creating and Saving a Trail A trail, or plot trail, is a string of position points plotted by the GlobalMap 7000C as you travel. They are particularly handy when you are trying to retrace your trip and go back the way you came. On the screen, trails are represented by a magenta line extending from the back of the current position arrow. The GlobalMap 7000C is set at the factory to automatically create and record a trail while the unit is turned on. The unit will continue recording the trail until the length reaches the maximum trail point setting (default is 2, 000, but the unit can record trails 9, 999 points long). When the point limit is reached, the GlobalMap 7000C begins recording the trail over itself. By default, the trail flashes once a second, making it easier to see against the background map. With the default auto setting, the GlobalMap 7000C creates a trail by placing a dot (trail point) on the screen every time you change directions. (The methods used for creating a trail and the trail update rate can both be adjusted or even turned off. 5 for Trail Options. ) To preserve a trail from point A to point B, you must "turn off" the trail by making it inactive before heading to point C or even back to point A. When the current trail is set inactive, the GlobalMap 7000C automatically creates and begins recording a new trail. Press MENU|MENU| to MY TRAILS|ENT. 43 Visible symbol Active symbol Sequence for saving a trail and beginning a new one. The arrow to the right of Trail 17 indicates the trail is "active, " and the check to the left indicates the trail is visible on the map display. The right figure shows the Edit Trail menu, with the Active command selected. 2. As you left the Edit Trail menu, you will notice that a new trail was started with a new sequential number. In the example figure below, the new trail is number 15, showing zero points. [. . . ] This warranty gives you specific legal rights and you may also have other rights which may vary from state to state. REMINDER: You must retain the sales slip or sales receipt proving the date of your original purchase in case warranty service is ever required. LOWRANCE ELECTRONICS 12000 E. SKELLY DRIVE, TULSA, OK 74128 (800) 324-1356 119 How to Obtain Service. . . . . . in the USA: We back your investment in quality products with quick, expert service and genuine Lowrance parts. If you're in the United States and you have technical, return or repair questions, please contact the Factory Customer Service Department. [. . . ]