User manual LOWRANCE EP-80R THRU-HULL TEMP SENSOR QUICK GUIDE

[. . . ] 988-0154-442 Electronic Thru-Hull Temp Sensor Installation and Configuration Instructions This document shows how to install an EP-80R TH thru-hull temp sensor and how to connect it to a NMEA 2000® network. It also provides instructions on how to configure your temp sensor with Lowrance digital gauges (LMF-200 & LMF-400) and display units. NMEA 2000 is the communication bus standard developed by the National Marine Electronics Association (NMEA) for use in boats. Lowrance has introduced a line of products that can communicate over a NMEA 2000 network (LowranceNet). [. . . ] The following message will appear: Press Enter to Configure Temp Sensor. Press ENTER, which will open the Select Temp menu with three options: Water Temp, Outside Temp and Inside Temp. NOTE: If your temp sensor is not updated on the Bus Devices list, refresh the list by closing it and then access it again. To unconfigure a temp sensor: 1. Press MENU, use the UP and DOWN keys to select SYSTEM SETUP and press ENTER. The Bus Devices list will appear, showing all devices detected on the network. The following message will appear: Press Menu to UnConfig Device Name. Press ENTER to unconfigure the sensor and be directed to the Bus Devices list where the temp now will be listed as UnCfg Temp. Bus Devices highlighted in the System Setup menu (left). To reconfigure a temp sensor: To reconfigure a sensor, there must be a configuration name available (Water, Outside or Inside). If all three temp sensors have been configured, you will have to unconfigure a temp sensor to make its name available for reconfiguration. If you try to reconfigure a sensor when the desired configuration name is in use, a Name Already Selected message will appear. If all three temps are configured -- meaning there is no name configuration available -- follow the first set of instructions. If the desired configuration name is available, follow the second set of instructions. The first set of instructions below will show you how to switch the configuration of a water temp to an outside temp. If all temps configured (Configuration name unavailable): 1. Press MENU, use the UP and DOWN keys to select SYSTEM SETUP and press ENTER. 2. Select OUTSIDE TEMP and press ENTER to open the temp configuration menu. The following message will appear: Press Enter to UnConfig Device Name. Press ENTER to unconfigure the sensor and be directed to the Bus Devices list. The Outside temp is now unconfigured and will be displayed as UnCfg Temp. Its configuration name (Outside) is now available, so you will be able to use it to reconfigure the Water temp sensor. Highlight WATER TEMP and press ENTER, which will open the temp 17 configuration menu. That will direct you to the Temp Selection menu, which will have three options: Water, Outside and Inside. The temp you just reconfigured (formerly water temp) will now be displayed as Outside Temp. [. . . ] WE MAKE NO OTHER EXPRESS WARRANTY OR REPRESENTATION OF ANY KIND WHATSOEVER CONCERNING THIS PRODUCT. Your remedies under this warranty will be available so long as you can show in a reasonable manner that any defect or malfunction in materials or workmanship, or any non-conformity with the product's written specifications, occurred within one year from the date of your original purchase, which must be substantiated by a dated sales receipt or sales slip. Any such defect, malfunction, or non-conformity which occurs within one year from your original purchase date will either be repaired without charge or be replaced with a new product identical or reasonably equivalent to this product, at our option, within a reasonable time after our receipt of the product. If such defect, malfunction, or non-conformity remains after a reasonable number of attempts to repair by us, you may elect to obtain without charge a replacement of the product or a refund for the product. [. . . ]