User manual LOWRANCE 5200C

[. . . ] 988-0151-471 GlobalMap® 5200C GPS Mapping GPS Receiver Operation Instructions Copyright © 2006 Lowrance Electronics, Inc. No part of this manual may be copied, reproduced, republished, transmitted or distributed for any purpose, without prior written consent of Lowrance. Any unauthorized commercial distribution of this manual is strictly prohibited. Fishing Hot Spots® is a registered trademark of Fishing Hot Spots Inc. [. . . ] Press WPT|ENT|ENT|ENT| to waypoint name|ENT| to EDIT WAYPOINT|ENT|ENT. 2. Press or to change the first character, then press to the next character and repeat until the name is correct. Press ENT then EXIT|EXIT|EXIT|EXIT to return to the previous page display. Waypoint Symbol To edit waypoint symbol: 1. Press WPT|ENT|ENT|ENT| to waypoint name|ENT| to EDIT WAYPOINT|ENT| to CHOOSE SYMBOL|ENT. To return to the previous page, press EXIT|EXIT|EXIT|EXIT. Waypoint Position To edit waypoint position: 1. Press WPT|ENT|ENT|ENT| to waypoint name|ENT| to EDIT WAYPOINT|ENT. 2. Press or to change the first character, then press to the next character and repeat until the latitude is correct. Press or to change the first character, then press to the next character and repeat until the longitude is correct. When latitude and longitude are correct, return to the previous page: press EXIT|EXIT|EXIT|EXIT. Selecting a Waypoint To select a waypoint on the map (for navigating to, for editing, etc. , ) use the arrow keys and center the cursor over the waypoint. Set a Waypoint by Average Position This feature sets a waypoint at the current position after taking several position readings and averaging them. 69 This boosts waypoint position accuracy by helping to eliminate errors caused by atmospheric conditions and other factors. When the desired number of points accumulates, press ENT to create and save the waypoint. You can save the waypoint by pressing EXIT|EXIT or you can edit the waypoint. Set a Waypoint by Projecting a Position This feature sets a waypoint at a point located a specific distance and bearing from a reference position. The reference position can be selected from your waypoint list, a map feature or from the Points of Interest list. When the point has been selected, press ENT and the point's position appears as the reference position. Press or to change the first character, then press to the next character and repeat until the distance is correct. Press or to change the first character, then press to the next character and repeat until the bearing is correct. You can save the new projected waypoint by pressing EXIT|EXIT or you can edit the waypoint. Press EXIT|ENT if you want to immediately begin navigating to the new waypoint. 70 Section 5: System & GPS Setup Options Alarms This unit has several GPS alarms. The factory default setting has all of these but the anchor alarm turned on. [. . . ] If you're in the United States and you have technical, return or repair questions, please contact the Factory Customer Service Department. Before any product can be returned, you must call customer service to determine if a return is necessary. Many times, customer service can resolve your problem over the phone without sending your product to the factory. Central Standard Time, M-F 800-324-1356 Lowrance Electronics may find it necessary to change or end our shipping policies, regulations, and special offers at any time. [. . . ]