User manual LORUS V657

[. . . ] Press "B" repeatedly to reset the stopwatch second and minute hands to the "0" position. Push the crown back into the normal position. s HOW TO SET THE TIME/CALENDAR · If the stopwatch is in use, be sure to reset it before setting the time. Second hand Hour hand Minute hand s DISPLAY AND CROWN OPERATION Stopwatch 1/10-second hand Hour hand Stopwatch minute hand Minute hand A A Date Crown 6 Crown Second click S ec o n d ha n d B Date Second click First click B First click Normal pos ition Stopwatch second hand Crown : Normal position : Free First click : Setting the date Second click : · Setting the time · Adjusting the stopwatch hand position 1. P u l l o u t t h e c r o w n t o t h e s e c o n d c l i c k when the second hand is at the 12 o'clock position. [. . . ] When the measurement is stopped, it will move to indicate the elapsed 1/10 seconds. B Second click Stopwatch operation Standard measurement Stopwatch second hand A Start A Stop B Reset Accumulated elapsed time measurement A Start A Stop A Restart A Stop B Reset * Restart and stop of stopwatch can be repeated by pressing button "A". Split time measurement 1. P r e s s a n d h o l d " A " a n d " B " a t t h e s a m e time for 2 seconds, and then release the buttons. * The stopwatch second hand turns half a circle counterclockwise and then returns where it was. The stopwatch 1/10-second hand turns a full circle clockwise and stops. Press "A" repeatedly to reset the stopwatch 1/10-second hand to the "0" position. Press "B" repeatedly to reset the stopwatch second and minute hands to the "0" position. * For details, refer to "HOW TO SET THE T IME/CALENDAR ") 5. Push the crown back into the normal position. A Start B Split B Split release A Stop B Reset s LUMIBRITE WATCH (dial, hands, buttons, case, bezel, strap, etc. ) * Measurement and release of split time can be repeated by pressing button "B". Note: When "B" is pressed to reset the stopwatch to "00", the stopwatch second and minute hands return to "0" position in 40 seconds. 6 If your watch is a LORUS LUMIBRITE watch, it has following features. LORUS LUMIBRITE watches absorb and store light energy from natural and artificial light sources and emit light in the dark. They are made of environmentally friendly material, and therefore, are harmless to human beings and the environment. · With a full charge, LORUS LUMIBRITE watches glow in the dark hours longer than conventional luminous watches of this type. If exposed to a light of more than 500 lux (i. e. , the brightness of a typical office) for approximately 10 minutes, or direct sunlight for 2 minutes, they will glow for hours. · Since LORUS LUMIBRITE watches emit the light they store, the brightness will decrease gradually over time. The length of time they will glow may also differ slightly depending on such factors as the brightness of and distance from the light source used to charge the watch. s BATTERY CHANGE The miniature battery SEIKO SR920SW, Maxell SR920SW, SONY SR920SW, Matsushita SR920SW or EVEREADY 371, which powers your watch should last approximately 2 years. However, because it is inserted at the factory, the actual life of the battery once in your possession may be less than the specified period. Be sure to replace the battery to prevent any possible malfunction as soon as it runs down. [. . . ] Please wear the watch with some play to avoid any possible allergic reaction. If you develop a rash on your wrist, stop wearing and consult a physician. · MAGNETISM Your watch will not be affected by magnetism generated by household electric appliances. [. . . ]