User manual LORUS 737

[. . . ] P r e s s b u t t o n " A " f o r 2 t o 3 s e c o n d s t o show the time/calendar setting display. Selection of the digits to be adjusted (flashing) is made in the following order by pressing button "C". Seconds Minutes Hour Year 12- or 24-hour indication Date Month 4. Digits except seconds and 12/24-hour indication move quickly by keeping button "D" pressed. [. . . ] Press button "C" to select the digits to be adjusted (flashing). Digits move quickly by keeping button "D" pressed. 3 . After all the adjustments are completed, press button "A" to return to the TIMER mode . * If the watch is left untouched in the timer setting display with the digits flashing, it will automatically return to the TIMER mode in 2 to 3 minutes. C Start C Stop C Restart ** Time-up * W arning s ound beeps. ** Restart and stop of the timer can be repeated by pressing button "C". After the set time is up, the timer counts up the time up to 59 minutes and 59 seconds. Once the timer is set, the set time is retained and can be used repeatedly unless it is readjusted. C Stop D Reset s ALARM MODE · The alarm can be set to ring on a 24-hour ba sis. s NOTE ON UNUSUAL DISPLAY 5 . After all the adjustments are completed, press button "A" to return to the ALARM mode. When the time function is displayed in the 24-hour indication, the alarm is also displayed in the 24-hour indication. When setting the hour digits in the 12hour indication, check that AM/PM is properly set. If the watch is left untouched in the alarm setting display with the digits flashing, it will automatically return to the ALARM mode in 2 to 3 minutes. Engagement/disengagement of the alarm & turning on/off of the hourly time signal · With each press of button "C" in the ALARM mode, the alarm and hourly time signal are engaged and disengaged in the following order. Alarm engaged Hourly time signal engaged Both engaged Neither engaged · At the designated time, the alarm rings for 20 seconds and stop. · The alarm can be tested by keeping button "C" pressed in the ALARM mode. Checking the set alarm time · Press and hold button "D" in the TIME/ CALENDAR mode. While the button is kept pressed, the alarm time that has been set is displayed. Note: When the alarm is disengaged, the set alarm time will not be displayed. 6 If your watch is a LORUS LUMIBRITE watch, it has following features. LORUS LUMIBRITE watches absorb and store light energy from natural and artificial light sources and emit light in the dark. They are made of environmentally friendly material, and therefore, are harmless to human beings and the environment. · With a full charge, LORUS LUMIBRITE watches glow in the dark hours longer than conventional luminous watches of this type. If exposed to a light of more than 500 lux (i. e. , the brightness of a typical office) for approximately 10 minutes, or direct sunlight for 2 minutes, they will glow for hours. [. . . ] Be sure to replace the battery to prevent any possible malfunction as soon as it runs down. To replace the battery, we recommend taking the watch to a local watch repair shop. Note: If the illuminating light is used for more than 4 seconds a day, the alarm more than 20 seconds a day and/or the timer warning sound more than 20 seconds a day, the battery life may be less than the specified period. When you r LOR US w atch req u ires repa ir or servicing, please see the enclosed WARRANTY/GUARANTEE. Printed in Hong Kong s CARE OF YOUR LORUS WATCH · BATTERY CAUTION Do not expose the old battery to fire or recharge it. [. . . ]