User manual LOGITECH PURE-FI ANYWHERE

[. . . ] When moving toward the far edge of the Pure-Fi MobileTM's range, audio may become distorted and/or the connection will cut in and out. Call answer button Call end button Microphone mute button Battery life indicator button Microphones Power button Bluetooth® / USB connection English Before using the product, please make sure you charge it for at least 3 hours. When fully charged, green battery life indicator ( ) will stop blinking. Move Pure-Fi MobileTM closer to the Bluetooth® receiver/audio source. [. . . ] Pure-Fi MobileTM can "pair" with up to 4 different devices separately, but only one device can be in use at a time. Please refer to section 5 for step by step instructions on how to pair Pure-Fi MobileTM to a mobile phone. Connect Pure-Fi MobileTM to computer with provided USB cable into to the back of the Pure-Fi MobileTM and into an available USB port on your computer (see section 3). NOTE: If already connected to a mobile phone, the Source button must be pressed to select the USB connection ( ). You may need to configure your operating system to use your Pure-Fi MobileTM speaker as the default audio device. Go to the START menu, choose Control Panel, then Sound and Audio Devices. Go to the Start menu, choose Control Panel, choose Classic view, choose Sounds. Choose the Playback tab, select the "Pure-Fi MobileTM" as the Sound Playback device if it is not already set as Default. Choose Recording tab, select the "Pure-Fi MobileTM" as the Recording Playback device if it is not already set as Default. Choose the Configure tab, Select "Set up microphone, " then select "Other. Status Power On Charging Speaker Speaker Charged Speaker Connected via Bluetooth® Speaker in Pairing Mode Speaker Connected via USB Microphones Muted Low Battery Music via Bluetooth® ( ( ( ( ( ( ( ( ( Action ) is solid green ) is blinking green ) is solid green ) blinking green ) blinking red / green / ) solid green / ) both solid red ) solid red ) solid green ) solid green ) blinking red ) blinking red / ) both blinking red ) blinking red Etat Activation Charge du haut-parleur en cours Haut-parleur chargé Haut-parleur connecté via Bluetooth® Haut-parleur en mode de couplage Haut-parleur connecté via USB Son des microphones coupé Batterie faible Musique via Bluetooth® Stereo XL activé Le haut-parleur recherche le dispositif stéréo Bluetooth® (A2DP) couplé (uniquement) Le haut-parleur recherche le dispositif mains libres couplé (uniquement) ( ( ( ( ( ( ( ( ( ( ( ( / Action ) is solid green ) is blinking green ) is solid green ) blinking green ) blinking red / green / ) solid green / ) both solid red ) solid red ) solid green ) solid green ) blinking red ) blinking red ) both blinking red ) blinking red Logitech, the Logitech logo, and other Logitech marks are owned by Logitech and may be registered. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. No naked (open) flame sources, such as lighted candles, should be placed on or near the apparatus. No objects filled with liquids, such as vases, shall be placed on or near the apparatus. Operate the apparatus only from the low level audio line output jack of the computer or of an audio device. If headphone jack is provided, the following warning should be observed: Excessive or extended sound pressure from earphones and headphones can cause hearing damage or loss. For portable apparatus or apparatus weighing 7kg (15 lbs) or less: the product label may be affixed under a lid, on the exterior of the bottom, or on the stands of the apparatus. The apparatus shall be disconnected from the mains by placing the power/standby switch in the standby position and unplugging the power cord of the apparatus from the AC mains receptacle. [. . . ] Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped. Do not push objects into apparatus vents or slots because fire or electric shock hazards could result. Maintain a minimum distance of at least 15 cm (6 inches) around apparatus for sufficient ventilation. Ventilation should not be impeded by covering the ventilation openings with items such as newspapers, tablecloths, curtains, etc. [. . . ]