User manual LOGITECH ALERT 750E GETTING STARTED GUIDE

[. . . ] Getting started with Logitech AlertTM 750e 1 2 3 4 5 ! Legal Warning: Certain uses of security camera products and audio devices, such as employee monitoring, surreptitious viewing and recording of images and/or audio, or the use, publication or distribution of image and/or audio recordings, are prohibited or restricted by country, state and local laws. Be sure to comply with the laws in your country, state, and locality when using Logitech Alert products and services. 1 Install Software ! Internet access is required for installation. NPO 6 7 8 9 10 Logitech AlertTM Video Security System Before you begin: Read all instructions before beginning the installation. During installation, we will test your PC's firewall settings. If prompted to allow Logitech Alert access to the network, you should always answer "Yes. " Network Adapter / Power Supply Install Note Logitech Quick-start guide AlertTM 700e/750e ents System Requirem & Support Guide Quick-start guide GETTING TO KNOW Do NOT plug the network adapter or power supply into a surge protector or power strip as they interfere with the cameras. [. . . ] 2d) Plug the power connector into the plug slider and plug the power supply into an outlet. 1 1a 1b 2 2b 2a INTE RNE T 2c 2d 1 2 3 4 1 1a 2 · Shortly after connecting, your camera will appear in Alert Commander. You can now move the camera to its desired location. Power Supply Install Note The power supply unit is weatherproof and can be installed outdoors. 1) Do NOT plug the power supply into the wall so that it lays horizontally or flat. 3) Avoid direct sunlight. Wall/Ceiling Mounting Instructions The wall mount allows you to easily fasten your camera to a wall, post, overhang, or other surface. 1) Start by pre-drilling holes into the base surface and then fastening the mouting base with the included screws. 1 2) Assemble the mounting arm and attach it to the base. RECOMMENDATION: Mount the Outdoor Camera under an eave or other overhang so that it is not exposed to direct sunlight. 1 2 3 2 3 ! or ! CAUTION: If left in sunlight, surface may be hot to the touch. Congratulations! You have completed the basic setup. Refer to the Getting to Know guide to read about additional features and functions. FAQs Where can I find more information? Commander Help You can press the F1 key from any screen in the Alert Commander to access the online Help system. Knowledge Base Troubleshooting help is available at www. logitech. com/support Customer Support Call 1. 888. 469. 4543 What do I do if I need a longer power supply cable?Logitech CAT-5e cables have been specially designed to create a weatherproof seal when attached to the camera and power supply. Longer cables are available for purchase at www. logitech. com/dvs/ (Accessories). Troubleshooting camera connection: What if camera/video disappears?1) Test another outlet for your camera, perhaps one closer to your PC. 2) Verify that the camera power supply and the network bridge are plugged directly into a power outlet and not a power strip. 3) Check firewall settings or press the F1 key in Commander Software for additional help. See instructions in "Camera Reset Instructions. " Camera Reset Instructions Insert a paper clip into the reset hole located on the back of the camera and press gently and then release. HELP Logitech AlertTM Video Security System Refer to System Requirements Guide. Quick-start guide GETTING TO KNOW Want to see more FAQs? h AlertTM 700e/750e Log Quick-start itec m Requirements guide Syste & Support Guide Go to www. logitech. com/security/support If the camera does not appear after reset, go to Settings > Cameras > Add/Find > Find Cameras. [. . . ] Logitech, the Logitech logo, and other Logitech marks are owned by Logitech and may be registered. Logitech assumes no responsibility for any errors that may appear in this manual. Information contained herein is subject to change without notice. 2 3 ! microSD card must be installed in the camera for recording to occur. microSD Logo is a trademark of SD-3C, LLC. 620-002012 rev005 [. . . ]