User manual LIQUID IMAGE EXPLORER 304

[. . . ] Explorer Series 8. 0MP Models UDCM 304 RPR TE Explorer Series xp DEPTH r lo rer Se 15ft 5m OF O WA User Manual - Underwater Digital Camera Mask Bedienungsanleitung - Taucherbrille mit Digitalkamera Manuale d'uso - Maschera con Macchina Fotografica Digitale Subacquea Gebruiksaanwijzing - Brimasker met ingebouwde Digitale Onderwatercamera Manuel Utilisateur- Le masque d'appareil photo numérique sous-marin Manual del usuario - Máscara con cámara digital subacuática Manual de instruções - Máscara Digital subaquática de Câmera Användarhandbok - Dykarglasögon med digitalkamera Brukerhåndbok - Undervannsmaske for digitalkamera Εγχειρίδιο Χρήσης ES032011VERS2 ENGLISH DEUTSCH ITALIANO NEDERLANDS FRANCAIS ESPANOL PORTUGUES SVENSKA NORSK Ελληνικά ΥΠΟΒΡΥΧΙΑ ΜΑΣΚΑ ΜΕ ΕΝΣΩΜΑΤΩΜΕΝΗ ΨΗΦΙΑΚΗ ΦΩΤΟΓΡΑΦΙΚΗ ΜΗΧΑΝΗ © 2011 Liquid Image Co, LLC. All rights reserved ie s TM E ENGLISH ATTENTION This manual explains how to safely operate the Underwater Digital Camera Mask. Keep this manual in a safe place for later reference Disclaimer While every effort has been made to ensure that the information contained in the guide is accurate and complete, no liability can be accepted for any errors or omissions. Liquid Image Co reserves the right to change the specifications of the hardware and software described herein at any time without prior notice. [. . . ] Press and hold the power button until you see the MODE LIGHT INDICATOR disappear. Remain in shallow water and practice using the buttons on the CAMERA MASK to record images and video until you are comfortable wearing and using the CAMERA MASK while swimming. CAUTION: For use while snorkeling or scuba diving, be sure you are comfortable with the fit and use of the mask and camera functions prior to use during an excursion. Perform the Camera Test prior to every excursion to check that all parts are functioning. CAUTION: The CAMERA MASK compartments should only be opened in a safe indoor environment (away from sand and water) to perform necessary operations. NEVER open any compartment that is sealed with screws. 7. 0 CARE AND MAINTENANCE When you are finished using the CAMERA MASK, always clean and wipe away any water, sand, salt, or other debris before opening or storing. Check all three caps for water tight closure before exposing to water. Always rinse the CAMERA MASK in FRESH WATER to remove any sand, salt or other debris. Do not use hot water or high pressure which may damage camera. ENG-16 3. Carefully press around the seams of all compartments to absorb any water left in the cracks. Once the camera is completely dry on the outside, check to make sure that you are also thoroughly dry including your hands, hair, and clothes before opening any compartments. This precaution is necessary so that you will not drip water into or onto the camera. If you find any moisture, sand or debris caught inside the threads of the outer compartment wall, immediately remove them with a cloth or cotton swab. If any moisture or debris has accumulated inside a compartment use a cotton swab to remove it, being careful not to touch the CAMERA MASK electronic components. Then inspect and clean the inside of the cap prior to positioning over the open compartment. To keep the O-RINGS working properly, wipe sand, salt, or debris away from the O-RING after use. and apply a thin layer of SILICONE GREASE to the O-RING before closing compartment. 1 Keep the CAMERA MASK at normal room temperatures that do not fluctuate 11. Exposure to extreme temperatures or temperature fluctuations may cause condensation inside the CAMERA MASK which may damage the device. Set in a dry area with room temperature until the condensation disappears. HUMID CLIMATES - Make sure to only open the camera briefly in Humid Climates as moisture in the air may be trapped in the inner compartments if the camera caps are left opened for a period of time. This will result in condensation on the LENS when the CAMERA MASK is submerged in warm water. [. . . ] Be careful not to touch any camera components inside the MEMORY COMPARTMENT OR BATTERY COMPARTMENT. If no water or debris were found in any of the compartments, check to see if the battery power is out by replacing the batteries with two new batteries. If your CAMERA MASK has stopped recording images or video, check to see if the memory is full. If the camera is "Frozen" or not functioning while on, there may be an issue ENG-22 with the battery. [. . . ]