User manual LINKSYS WVC200

[. . . ] 2. 4 GHz Wireless-G 802. 11g WIRELESS PTZ Internet Camera with Audio User Guide Model No. WVC200 Wireless-G PTZ Internet Camera with Audio Copyright and Trademarks Specifications are subject to change without notice. Other brands and product names are trademarks or registered trademarks of their respective holders. How to Use this Guide This User Guide has been designed to make understanding networking with the Camera easier than ever. Look for the following items when reading this guide: This checkmark means there is a Note of interest and is something you should pay special attention to while using the Camera. This exclamation point means there is a Caution or warning and is something that could damage your property or the Camera. [. . . ] Displayed here is the Camera's identification name, which is used by the Camera and the Utility to exchange data. Unique, memorable names are helpful, especially if you are using multiple Cameras on the same wireless network. This feature allows you enable or disable the Camera's LEDs. Chapter 7: Using the Wireless-G Internet Camera's Web-based Utility Setup Figure 7-5: Basic Screen 43 Wireless-G PTZ Internet Camera with Audio Date. If you want to update the Camera's time through an NTP (Network Time Protocol) server on the Internet, click the first checkbox. When the NTP feature is enabled, the daylight savings option will be available. If you want to adjust the Camera's current time for daylight savings, click the second checkbox. LAN Settings Configuration Type. If the Bridge will obtain an IP address automatically from a DHCP server, then select Automatic Configuration - DHCP. If you will assign the Camera a static IP address, then select Static IP Address, and complete the IP Address, Subnet Mask, Gateway, and DNS fields. You need to enter at least one DNS address. Wireless Settings SSID. If the Camera is set to ad-hoc mode, select its channel setting from the drop-down menu. You will be asked to confirm that you want to enable wireless security for the Camera. For more information, go to the "Security Settings" section. To get additional information about the screen's features, click the Help button. Figure 7-6: Confirmation Screen Security Settings Configure the Camera's WEP encryption settings on this screen. Select which WEP key (1-4) will be used when your network's access point or wireless router sends and receives data. Chapter 7: Using the Wireless-G Internet Camera's Web-based Utility Setup 44 Wireless-G PTZ Internet Camera with Audio WEP Encryption. Select the level of WEP encryption you wish to use, 64 Bit Keys (10 Hex chars) or 128 Bit Keys (26 Hex chars). Instead of manually entering WEP keys, you can use a Passphrase to generate them. It is casesensitive and should not be longer than 16 alphanumeric characters. If you are also using non-Linksys wireless products, you will need to enter your WEP keys manually on those products. ) After entering the Passphrase, click the Generate button to create WEP key(s). If you are used a Passphrase, the WEP keys will be displayed after you have generated them. If you are not using a Passphrase, manually enter a set of values in each field. (For 128-bit WEP, only one WEP key is permitted. ) If you are using 64-bit WEP encryption, then each key must consist of exactly 10 hexadecimal characters. [. . . ] Some jurisdictions do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to You. 71 Appendix G: Warranty Information Wireless-G PTZ Internet Camera with Audio Appendix H: Regulatory Information FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ]