User manual LINKSYS WRT54GX2

[. . . ] ® A Division of Cisco Systems, Inc. 2. 4 GHz Wireless-G 802. 11g Broadband Router WIRELESS with SRX200 User Guide Model No. WRT54GX2 Wireless-G Broadband Router with SRX200 Copyright and Trademarks Specifications are subject to change without notice. Other brands and product names are trademarks or registered trademarks of their respective holders. WARNING: This product contains chemicals, including lead, known to the State of California to cause cancer, and birth defects or other reproductive harm. Wash hands after handling. How to Use This User Guide This User Guide has been designed to make understanding networking with the Wireless-G Broadband Router easier than ever. [. . . ] You can assign a static IP address to a PC by performing the following steps: · For Windows 98SE and Me: 1. In The following network components are installed box, select the TCP/IP-> associated with your Ethernet adapter. If you only have one Ethernet adapter installed, you will only see one TCP/IP line with no association to an Ethernet adapter. In the TCP/IP properties window, select the IP address tab, and select Specify an IP address. Enter a unique IP address that is not used by any other computer on the network connected to the Router. Make sure that each IP address is unique for each PC or network device. Click the Gateway tab, and in the New Gateway prompt, enter 192. 168. 1. 1, which is the default IP address of the Router. Enter the Host and Domain names (e. g. , John for Host and home for Domain). If your ISP has not provided the DNS IP address, contact your ISP to get that information or go to its website for the information. Click the OK button in the TCP/IP properties window, and click Close or the OK button for the Network window. Restart the computer when asked. Appendix A: Troubleshooting Common Problems and Solutions 41 Wireless-G Broadband Router with SRX200 · For Windows 2000: 1. Right-click the Local Area Connection that is associated with the Ethernet adapter you are using, and select the Properties option. In the Components checked are used by this connection box, highlight Internet Protocol (TCP/IP), and click the Properties button. Enter a unique IP address that is not used by any other computer on the network connected to the Router. Enter the Default Gateway, 192. 168. 1. 1 (Router's default IP address). Toward the bottom of the window, select Use the following DNS server addresses, and enter the Preferred DNS server and Alternative DNS server (provided by your ISP). Click the OK button in the Internet Protocol (TCP/IP) Properties window, and click the OK button in the Local Area Connection Properties window. · For Windows XP: The following instructions assume you are running Windows XP with the default interface. If you are using the Classic interface (where the icons and menus look like previous Windows versions), please follow the instructions for Windows 2000. Click the Network and Internet Connections icon and then the Network Connections icon. Right-click the Local Area Connection that is associated with the Ethernet adapter you are using, and select the Properties option. In the This connection uses the following items box, highlight Internet Protocol (TCP/IP). [. . . ] However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which is found by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna Increase the separation between the equipment or devices Connect the equipment to an outlet other than the receiver's Consult a dealer or an experienced radio/TV technician for assistance FCC Radiation Exposure Statement This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body. INDUSTRY CANADA (CANADA) This device complies with Canadian ICES-003 and RSS210 rules. [. . . ]