User manual LINKSYS WRT54GP2A-AT

[. . . ] ® A Division of Cisco Systems, Inc. 2. 4 GHz Wireless-G 802. 11g WIRELESS Broadband Router with 2 Phone Ports User Guide Model No. WRT54GP2A-AT Wireless-G Broadband Router with 2 Phone Ports Copyright and Trademarks Specifications are subject to change without notice. Other brands and product names are trademarks or registered trademarks of their respective holders. WARNING: This product contains chemicals, including lead, known to the State of California to cause cancer, and birth defects or other reproductive harm. Wash hands after handling. How to Use this Guide Your guide to the Wireless-G Broadband Router with 2 Phone Ports has been designed to make understanding networking with the Router easier than ever. [. . . ] Launch Internet Explorer, and enter http://www. att. com/linksys in the Address field. If you already have an Internet phone service account with AT&T, then select I signed up for service and want to activate. If you do not have an Internet phone service account with AT&T, then select I have my Linksys Router and want to sign up for service. When you have activated your Internet phone service, the Phone 1 LED on the Router's front panel will light up. If you experience any problems, refer to "Appendix A: Troubleshooting" for more information. Figure 6-1: Website for AT&T CallVantage Service Chapter 6: Signing up for AT&T CallVantagesm Service Overview 44 Wireless-G Broadband Router with 2 Phone Ports Appendix A: Troubleshooting This appendix provides solutions to problems that may occur during the installation and operation of the Router. If you can't find an answer here, check the AT&T website at http://www. usa. att. com/callvantage/faqs/index. jsp or the Linksys website at www. linksys. com. Common Problems and Solutions 1. Go through this checklist until your problem is solved: · Make sure the telephone is plugged into the Phone 1 port. · Disconnect and re-connect the RJ-11 telephone cable between the Router and telephone. · Make sure your telephone is set to its tone setting (not pulse). Try to access the Internet, and check to see if the Router's Internet LED is lit. If you do not have a connection, power off your network devices, including the Router and cable/DSL modem. · Verify your account information and confirm that the phone line is registered with AT&T. · If none of the above works, contact AT&T at 1-866-596-8464. The Status - Voice screen of the Web-based Utility says that the registration for my Internet phone line has failed. Go through this checklist until your problem is solved: · Make sure your network has an active Internet connection. Try to access the Internet, and check to see if the Router's Internet LED is lit. If you do not have a connection, power off your network devices, including the Router and cable/DSL modem. · Verify your account information and confirm that the phone line is registered with AT&T. · Make sure that your cable or DSL modem is supported by AT&T. · If none of the above works, contact AT&T at 1-866-596-8464. If your Internet phone service account is active, the Router will automatically download its Internet phone service settings once it is connected to the Internet again. [. . . ] This equipment should be installed and operated with minimum distance 20cm between the radiator and your body. EC DECLARATION OF CONFORMITY (EUROPE) Linksys declares that this product conforms to the specifications listed below, following the provisions of the European R&TTE directive 1999/5/EC: EN 301 489-1, 301 489-17 General EMC requirements for Radio equipment. EN 609 50 Safety EN 300-328-1, EN 300-328-2 Technical requirements for Radio equipment. Caution: This equipment is intended to be used in all EU and EFTA countries. [. . . ]