User manual LINKSYS WPS54GU2

[. . . ] ® A Division of Cisco Systems, Inc. 2. 4 GHz Wireless-G 802. 11g PrintServer for USB 2. 0 WIRELESS Model No. User Guide WPS54GU2 Wireless-G PrintServer for USB 2. 0 Copyright and Trademarks Specifications are subject to change without notice. Other brands and product names are trademarks or registered trademarks of their respective holders. How to Use this User Guide This User Guide has been designed to make understanding networking with the PrintServer easier than ever. Look for the following items when reading this User Guide: This checkmark means there is a note of interest and is something you should pay special attention to while using the PrintServer. This exclamation point means there is a caution or warning and is something that could damage your property or the PrintServer. [. . . ] If you are using 128-bit WEP encryption, then the key must consist of exactly 26 hexadecimal characters. Valid hexadecimal characters are "0"-"9" and "A"-"F". Click the Link Info button if you want to view information about the wireless connection. Click the Get Defaults button if you want to cancel your changes and use the default settings. When finished making your changes on this tab, click the OK button to save these changes, or click the Cancel button to undo your changes. For more information, click the Help button. Figure 7-18: Configuration - Wireless Chapter 8: Bi-Admin Management The Bi-Admin Management Utility 39 Wireless-G PrintServer for USB 2. 0 SNMP (Figure 8-19) · SysContact. From the Configuration Item box, select the number of the management station (M1M4) or trap receiver (T1-T4). For management stations, you can change the station's IP address, Community String, and Access Permission level. In the Manager IP Address fields, enter the IP address of the management station with the SNMP program installed. In the Community String field, enter the name of the SNMP community, which is usually public or private. In the Access Permission section, select the desired level of access for this management station, Read Only, Read/Write, or Not Accessible. For trap receivers, you can change the trap receiver's IP address, Community String, Trap Option, and Trap Severity level. In the Trap Receive IP Address fields, enter the IP address of the trap receiver that will be sent the trap messages or notifications. In the Community String field, enter the name of the SNMP community, which is usually public or private. For the Trap Severity setting, select the desired level of severity, with 1 meaning least severe. Click the Get Defaults button if you want to cancel your changes and use the default settings. When finished making your changes on this tab, click the OK button to save these changes, or click the Cancel button to undo your changes. Figure 7-19: Configuration - SNMP Chapter 8: Bi-Admin Management The Bi-Admin Management Utility 40 Wireless-G PrintServer for USB 2. 0 · Upgrade. Follow these instructions: 1 On the Upgrade screen shown in Figure 8-20, click the Files button. Select the LAN card the PrintServer is connected to, and then click the OK button. 3 Follow the on-screen instructions, and select the firmware file you want to use. 4 View the BIN File Information screen (see Figure 8-22), and click the OK button if you have selected the correct firmware file. [. . . ] End-users must be provided with specific operations for satisfying RF exposure compliance. Note: Dual antennas used for diversity operation are not considered co-located. Appendix I: Regulatory Information 66 Wireless-G PrintServer for USB 2. 0 INDUSTRY CANADA (CANADA) This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada. The use of this device in a system operating either partially or completely outdoors may require the user to obtain a license for the system according to the Canadian regulations. [. . . ]