User manual LINKSYS WPS54G

[. . . ] ® A Division of Cisco Systems, Inc. 2. 4 GHz Wireless-G 802. 11g PrintServer WIRELESS Model No. User Guide WPS54G Wireless-G PrintServer Copyright and Trademarks Specifications are subject to change without notice. Other brands and product names are trademarks or registered trademarks of their respective holders. WARNING: This product contains chemicals, including lead, known to the State of California to cause cancer, and birth defects or other reproductive harm. Wash hands after handling. How to Use this User Guide The user guide to the Wireless-G PrintServer has been designed to make understanding networking with the PrintServer easier than ever. [. . . ] For more information, click the Help button. Figure 7-12: Configuration - AppleTalk Chapter 7: Bi-Admin Management The Bi-Admin Management Utility 37 Wireless-G PrintServer NetBEUI · Domain Name. Enter the name of the domain that you want the PrintServer associated with in the Domain Name field. If you are unsure of the Domain Name, you can find it out by looking on any computer already on the network. In Windows 98, right-click Network Neighborhood and select Properties. Under the Identification tab, there will be listed that computer's name, and the Domain to which it is connected. If you want the PrintServer to be connected to that same Domain, enter that Domain name here. If no Domain name exists there, you will use the Workgroup name from that window. You can specify the Response Time that you prefer for the PrintServer. This is the amount of time (measured in seconds) that the PrintServer will wait for a response from the network before "timing out. " You also have the option to use this feature, Abort Print Job if Error. Selecting Yes here will terminate the printing if there is an error of any kind. If you select No, print jobs that have errors will be sent to the printer, but might not print properly. Click the Get Defaults button if you want to cancel your changes and use the default settings. When finished making your changes on this tab, click the OK button to save these changes, or click the Cancel button to undo your changes. Figure 7-13: Configuration - NetBEUI Chapter 7: Bi-Admin Management The Bi-Admin Management Utility 38 Wireless-G PrintServer Internet Printing · Mail Server. Enter the address of your mail server in the Mail Server IP Address fields. (This value must be a fixed IP address. ) Enter the Mail Account name and Password next. Then, enter the time interval for the PrintServer to check for e-mail to be printed, in hours and minutes in the Check Mail Interval field. You may also specify an e-mail address to which mails that cannot be printed are routed; this is useful for both graphic-intensive e-mails and for troubleshooting purposes. In the field provided, enter the Printer Model, which can be found through the Device Manager. Place a check mark next to the options you want to enable: Print Every Mail, Banner Printing (enabled by default), or Mail response when Printed. Click the Get Defaults button if you want to cancel your changes and use the default settings. When finished making your changes on this tab, click the OK button to save these changes, or click the Cancel button to undo your changes. [. . . ] INDUSTRY CANADA (CANADA) This Class B digital apparatus complies with Canadian ICES-003, RSS210. Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada. The use of this device in a system operating either partially or completely outdoors may require the user to obtain a license for the system according to the Canadian regulations. EC DECLARATION OF CONFORMITY (EUROPE) Linksys declares that this product conforms to the specifications listed below, following the provisions of the European R&TTE directive 1999/5/EC: EN 301 489-1, 301 489-17 General EMC requirements for Radio equipment. [. . . ]