User manual LINKSYS WAP4400N

[. . . ] USER GUIDE with Ports 4-portuter Wireless-N Access Point with Power Over Ethernet BUSINESS SERIES Model No. No. Wireless-N Access Point with Power Over Ethernet Copyright and Trademarks Specifications are subject to change without notice. Other brands and product names are trademarks or registered trademarks of their respective holders. WARNING: This product contains chemicals, including lead, known to the State of California to cause cancer, and birth defects or other reproductive harm. [. . . ] To confirm the new password, enter it again in this field. Web Access To increase the security on accessing the Web-based Utility, you can enable HTTPS. Once enabled, users need to use https:// when accessing the Web-based Utility. The default is Enabled. Figure 6-18: Administration - Management SNMP SNMP is a popular network monitoring and management protocol. It provides network administrators with the ability to monitor the status of the Access Point and receive notification of any critical events as they occur on the Access Point. The default is Disabled. Chapter 6: Configuring the Wireless-N Access Point The Administration - Management Tab 28 Wireless-N Access Point with Power Over Ethernet This Access Point supports SNMP version 1, 2, and 3. Select SNMP V1 & V2 if you don't need the enhanced capability on V3 or your management software does not support V3. Enter the name of the contact person, such as a network administrator, for the Access Point. Create a administrator account to access and manage the SNMP MIB objects. Enter the authentication password for administrator account (minimum length 8). Enter the passphrase for data encryption on administrator's management traffic. Enter the password that allows read-only access to the Access Point's SNMP information. Enter the password that allows read/write access to the Access Point's SNMP information. Enter the password required by the remote host computer that will receive trap messages or notices sent by the Access Point. You can restrict access to the Access Point's SNMP information by IP address. If this field is left blank, then access is permitted from any IP address. Enter the IP address of the remote host computer that will receive the trap messages. Change these settings as described here and click Save Settings to apply your changes, or click Cancel Changes to cancel your changes. Help information is displayed on the right-hand side of the screen, and click More for additional details. Chapter 6: Configuring the Wireless-N Access Point The Administration - Management Tab 29 Wireless-N Access Point with Power Over Ethernet The Administration - Log Tab On this screen you can configure the log settings and alerts of particular events. Log You can have logs that keep track of the Access Point's activities. Email Alert E-Mail Alert. If you want the Access Point to send e-mail alerts in the event of certain attacks, select Enabled. Figure 6-19: The Administration - Log Notification Queue Length Log Queue Length. The default is 600 seconds (10 minutes). Syslog Notification Syslog is a standard protocol used to capture information about network activity. The Access Point supports this protocol and sends its activity logs to an external server. [. . . ] The foregoing limitations will apply even if any warranty or remedy provided under this Agreement fails of its essential purpose. Some jurisdictions do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to You. 56 Appendix G: Warranty Information Wireless-N Access Point with Power Over Ethernet Appendix H: Regulatory Information FCC Statement This product has been tested and complies with the specifications for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. [. . . ]