User manual LINKSYS AE6000

[. . . ] to configure advanced settings , use the convenient , browser-based utility. Wireless  (Blue)  The Wireless LED lights up when there is a wireless connection. The LED flashes when the bridge is actively sending or receiving data over the wireless network. Wi-Fi Protected Setup Button  If your router supports Wi-Fi Protected Setup and uses WPA or WPA2 security, then you can use Wi-Fi Protected Setup to automatically connect the bridge. [. . . ] Timeout Internal  This option defines the timeout period in which the aggregate should be closed with a “closing condition” before it is closed by the timer. Size of Packet in Aggregation  This option defines the minimum size (in bytes) of packets to be accumulated in the aggregate. ADDBA Timeout  This option defines the duration after which the ADDBA setup is terminated, if there are no frame exchanges within this duration by the Block Acknowledgement (ACK) agreement. Aggregation Window Size  This option defines the maximum number of packets transmitted without getting ACKs. Click Save Settings to apply your changes, or click Cancel Changes to cancel your changes. Advanced Configuration ADDBA Timeout  This option defines the duration after which the ADDBA setup is terminated, if there are no frame exchanges within this duration by the Block Acknowledgement (ACK) agreement. Aggregation Window Size  This option defines the maximum number of packets transmitted without getting ACKs. Click Save Settings to apply your changes, or click Cancel Changes to cancel your changes. wireless > Advanced Wireless Settings Configure the bridge’s advanced wireless functions. These settings should only be adjusted by an expert administrator as incorrect settings can reduce wireless performance. Voice Use Aggregation  This option defines whether or not the Media Access Control (MAC) layer will set up an Add Block Acknowledgement (ADDBA) session. Idle Timeout  The login times out after a period of inactivity that you specify. Web Access Access via Wireless  If you are using the bridge in a public domain where you are giving wireless access to your guests, you can disable wireless access to the bridge’s browser-based utility. You will only be able to access the browserbased utility via a wired connection if you disable the setting. Keep the default, Enabled, to allow wireless access to the bridge’s browser-based utility, or select Disabled to block wireless access to the utility. Backup and Restore Backup  To back up the bridge’s configuration file, click Backup Configurations. Advanced Configuration Administration > Upgrade Firmware Use this screen to upgrade the bridge’s firmware. Do not upgrade the firmware unless you are experiencing problems with the bridge or the new firmware has a feature you want to use. system Reboot Reboot  To reboot or restart the bridge , click Start to Reboot. Click Save Settings to apply your changes, or click Cancel Changes to cancel your changes. Administration > Factory Defaults Use this screen to restore the bridge’s configuration to its factory default settings. Factory Defaults Restore All Settings  To reset the bridge’s settings to the factory defaults, click Restore All Settings. [. . . ] Alternativet for RTS/CTS gir bedre dekning, men lavere ytelse enn CTS2Self, ettersom alternativet for RTS/CTS inkluderer bekreftelse fra mottaksenheten. Klikk på Save Settings (Lagre innstillinger) for å ta i bruk endringene, eller klikk på Cancel Changes (Forkast endringer) for å forkaste endringene. Re-enter to confirm (Skriv inn på nytt for å bekrefte)  Skriv inn passordet på nytt for å bekrefte det. Behold standardinnstillingen, som er Enabled (Aktivert), hvis du vil tillate trådløs tilgang til det webbaserte verktøyet for broen, eller velg Disabled (Deaktivert) for å blokkere trådløs tilgang til verktøyet. [. . . ]